Effect of Sand and Dust Shading on the Output Characteristics of Solar Photovoltaic Modules in Desertification Areas
Open Access
Abstract
Photovoltaic power generation is rapidly developing as a kind of renewable energy that can protect the ecological environment. The establishment of photovoltaic power stations in desertification areas can play a very important role in desert windbreaks and sand fixation as well as improve the ecological environment. The realization of the effective integration of photovoltaics and deserts can have multiple benefits for the economy, society, and ecology. However, the deposition of sand and dust caused by environmental factors in desertification areas can seriously affect the power generation efficiency of PV modules. In this study, the output characteristics of photovoltaic modules were tested under three wind speed conditions (5 m/s, 10 m/s, and 15 m/s), with different sand densities, sand particle sizes, and inclination angles. The experimental study showed that the module’s output power gradually decreased with an increase in the density of accumulated sand; the sand accumulation density on the surface of the photovoltaic module increased from 0 to 40 g/m2, and the maximum output power decreased by 32.2%. As the sand particle size increased, the maximum output power of the module rose and was gradually stabilized in the three wind speed groups. As the sand particle size increased, the maximum output power of the module increased and gradually stabilized in the three wind speed groups. When the wind speed was 15 m/s, the component output power of the angle had the largest drop; the tilt angle was 60° when the relative output power rate reached the minimum (i.e., 86.5%); that is, there was electrical energy loss of approximately 13.7%. The sand particle size and accumulated sand density were the control variables related to the module temperature and the transmittance of the proportion of the impact of the module filling factor differences. According to the curve analysis of the filling factor in different sand accumulation densities, the filling factor first increased and then decreased. In this test, the filling factor at the sand accumulation density of 35 g/m2 (module temperature valley) reached the peak value. The change trend for the component filling factor under different sand particle sizes fluctuated.Keywords
All Related Versions
Funding Information
- Inner Mongolia Science and Technology Department (2020CG0066, 2022YFE0126900)
- Ministry of Science and Technology of People’s Republic of China (2020CG0066, 2022YFE0126900)
This publication has 27 references indexed in Scilit:
- Energy yield loss caused by dust deposition on photovoltaic panelsSolar Energy, 2014
- Fundamental studies on dust fouling effects on PV module performanceSolar Energy, 2014
- Temperature and wind speed impact on the efficiency of PV installations. Experience obtained from outdoor measurements in GreeceRenewable Energy, 2014
- Effect of dust accumulation on the power outputs of solar photovoltaic modulesRenewable Energy, 2013
- Renewable energy in buildings in China—A reviewRenewable and Sustainable Energy Reviews, 2013
- On the temperature dependence of photovoltaic module electrical performance: A review of efficiency/power correlationsSolar Energy, 2009
- Experimental study of mismatch and shading effects in the – characteristic of a photovoltaic moduleSolar Energy Materials and Solar Cells, 2006
- A comparative investigation of the TTU pressure envelope -Numerical versus laboratory and full scale resultsWind and Structures, 2002
- Numerical simulation of turbulent flow over surface-mounted obstacles with sharp edges and cornersJournal of Wind Engineering and Industrial Aerodynamics, 1990
- Cost studies on terrestrial photovoltaic power systems with sunlight concentrationSolar Energy, 1977