An In-Situ Galvanically Coupled Multielectrode Array Sensor for Localized Corrosion
Authors:
- L. YangLYL. Yang
- N. SridharNSN. Sridhar
- O. PensadoOPO. Pensado
- 1 December 2002
- journal article
- Published by Association for Materials Protection and Performance (AMPP) in Corrosion
- Vol. 58 (12) , 1004-1014
Abstract
A localized corrosion sensor consisting of multiple, corrodible, miniature electrodes was tested in different chemical environments. The miniature electrodes were coupled together by connecting each of them to a common joint through independent resistors, with each electrode simulating an area of a corroding metal. In a localized corrosion environment, anodic currents flow into the more corroding electrode, and cathodic currents flow out of the less or noncorroding electrodes. These currents are measured from the voltages across the resistors. The variation among the galvanic currents measured from the miniature electrodes responded well to changes in the environment with respect to localized corrosion. It was demonstrated that statistical parameters derived from the currents flowing through the miniature electrodes, such as the standard deviation or the 90th percentile anodic value, can be used as effective indictors for localized corrosion. Measurement showed the following order of corrosiveness of the environment for UNS S30400 stainless steel: deionized water < saturated potassium chloride (KCl) < 1 M sodium nitrate (NaNO3) + 0.25 M ferric chloride (FeCl3) < 0.0025 M FeCl3 < 0.25 M FeCl3. It was also shown that the penetration rate of localized corrosion may be estimated from either the measured maximum or the standard deviation of the anodic current densities, and the cumulative penetration may be estimated from either the measured maximum or the standard deviation of the cumulative anodic charges through the electrodes.Keywords
This publication has 19 references indexed in Scilit:
- A Novel Electrochemical Testing Method and Its Use in the Investigation of Underfilm Corrosion of Temporarily Protective Oil CoatingCorrosion, 2000
- Mapping Corrosion Kinetics Using the Wire Beam Electrode in Conjunction with Electrochemical Noise Resistance MeasurementsJournal of the Electrochemical Society, 2000
- In Situ Study of Salt Film Stability in Simulated Pits of Nickel by Raman and Electrochemical Impedance SpectroscopiesJournal of the Electrochemical Society, 1997
- Wire-beam electrode: a new tool for investigating electrochemical inhomogeneity of oil coatingsProgress in Organic Coatings, 1997
- Metastable pitting corrosion of stainless steel and the transition to stabilityPhilosophical Transactions A, 1992
- Nucleation of corrosion pits on stainless steelPhilosophical Magazine Letters, 1992
- A spectrum analysis of potential fluctuation during passive film breakdown and repair on ironCorrosion Science, 1992
- Localized Corrosion of Sputtered Aluminum and Al‐0.5% Cu Alloy Thin Films in Aqueous HF Solution: I . Corrosion PhenomenaJournal of the Electrochemical Society, 1990
- The Polarization Resistance Technique for Measuring Corrosion Currents1976
- The Behavior of Resistive Layers in the Localized Corrosion of Stainless SteelJournal of the Electrochemical Society, 1973