INFLUENCE OF MICROSTRUCTURE FEATURES ON WEAR BEHAVIOUR OF Ti-64 TITANIUM ALLOY
Author:
Open Access
- 1 April 2016
- journal article
- Published by Egyptian Knowledge Bank in The International Conference on Applied Mechanics and Mechanical Engineering
- Vol. 17 (17) , 1-11
Abstract
The mild to severe wear transition of Ti-6Al-4V titanium alloy was investigated. Thecorrelation between microstructure and wear micro-mechanisms was also studied.Hot swaging at 900 °C was performed on the as-cast samples and thereafter twodifferent solution treatments were applied on the swaged samples. The first treatmentwas applied at a temperature of 850 °C (below the -transus temperature) for gettinga bimodal structure (+), while the second treatment at 1050 °C was applied (abovethe -transus) for getting lamellar structure (). The solution treated lamellar structureresulted in ultimate strength of 1335 MPa and a hardness of 440 HV20 which aresignificantly superior to the bimodal structure. Wear behaviour of the studied Ti64alloy was investigated at different sliding speeds in the range of 0.5 to 2.5 m/s withan interval of 0.5 m/s. The mild to severe wear transition was obtained at 1.5 m/s.The lowest wear rate was reported for the samples solution treated at 1050 °C due totheir fine lamellae structure with high hardness. The worn surfaces of some selectedsamples were examined using SEM to determine the wear micro-mechanisms.Keywords
This publication has 22 references indexed in Scilit:
- Degradation of titanium 6Al–4V fatigue strength due to electrical discharge machiningInternational Journal of Fatigue, 2014
- Wear failure behaviour of titanium-based oxide coatings on a titanium alloy under impact and sliding forcesJournal of Alloys and Compounds, 2013
- Tribological behaviour of near β titanium alloy as a function of α+β solution treatment temperatureMaterials & Design (1980-2015), 2013
- Influence of Cooling Rate and Aging on the Lamellar Microstructure and Fractography of TC21 Titanium AlloyMetallography, Microstructure, and Analysis, 2013
- Effect of Annealing Temperature on Microstructure and Mechanical Properties of Hot Swaged cp-Ti Produced by Investment CastingJournal of Materials Engineering and Performance, 2010
- Nucleation and variant selection of secondary α plates in a β Ti alloyActa Materialia, 2008
- Friction and wear behaviour of cp Ti and Ti6Al4V following nitric acid passivationApplied Surface Science, 2006
- The effect of annealing temperatures and cooling rates on microstructure and mechanical properties of investment cast Ti–6Al–4V alloyMaterials & Design (1980-2015), 2006
- Biocompatibility of β-stabilizing elements of titanium alloysBiomaterials, 2004
- Microstructure evolution during alpha-beta heat treatment of Ti-6Al-4VMetallurgical and Materials Transactions A, 2003