Abstract
Choice of proper equipment is crucial in skiing since it could alter the safety and performance. Ski bindings are a major element related to these aspects and in particular Alpine Touring (AT) bindings available in the market show conceptually different design solutions. We identified three macro categories of AT bindings distinguished by the clamp mechanisms at heel and toe. Then, we took a representative model for each, aiming to test if the structural differences of these bindings influence the repartition of edging torque between front and rear parts of the binding. We hypothesize that the tightness of the joint mechanism and its fully metallic construction makes the frontal connection of pin bindings very stiff therefore driving most of the torque to the front binding, which doesn’t happen in alpine-style bindings since the two clamp connections show similar contact geometry. To test our hypothesis, we used two dynamometric plates mounted under each binding, and we measured the front, rear, and total ski edging torque in indoor and skiing experiments. Results confirmed our hypothesis showing that pin bindings can drive up to 92 % of the total torque to the front piece, while alpine-style bindings are really close to an even distribution. This evidence should be considered when designing AT ski boots to guarantee proper structural properties. Moreover, these differences should also be carefully looked towards safety regulations and release characteristics of AT bindings.

This publication has 9 references indexed in Scilit: