Role of oscillation frequency and amplitude on the microstructure and properties of linear friction welded nickel aluminium bronze joints
Open Access
- 7 May 2024
- journal article
- research article
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (6) , 065926
Abstract
This study explores the influence of oscillation frequency and amplitude on the quality of linear friction welded joints using as-cast nickel aluminium bronze. Welding was conducted at 30 Hz, 50 Hz, and 70 Hz oscillated frequencies and amplitudes of 1.5 mm, 2 mm, and 3 mm. The joint’s performance was thoroughly investigated through systematic analysis, including macrostructure examination, peak interfacial temperature measurement, microstructure evaluation, strain assessment, cooling rate determination, microhardness testing, and tensile property characterization. The width of the weld zone varied from 183 μm to 297 μm, and the thermomechanical affected zone (TMAZ) area ranged from 4.48 mm2 to 14.79 mm2 across different process parameters. In the parent material, the volume fraction of the β-phase was as low as 20.2%, contrasting with the dominant α-phase at 79.8%. The average grain size of the lamellar and globular α-phase mixture was 26.4 μm. Notably, the weld zone exhibited extremely refined α-phase grains, with diameters less than 5 μm in all cases. The volume fraction of the β‘-phase increased significantly with higher frequencies, from 15.299% at 30 Hz to 26.98% at 50 Hz, peaking at 40.08% at 70 Hz, leading to varying k phases. This variation in microstructure had a substantial impact on mechanical properties. Tensile strength ranged from 503 MPa to 582 MPa, while ductility varied from 13.5% to 21.7%. Additionally, the hardness of the parent material increased from approximately 155 Hv to 260 Hv. This study demonstrates that controlling the oscillation frequency and amplitude in linear friction welding processes can yield consistent, high-quality welds in nickel aluminium bronze.Keywords
This publication has 48 references indexed in Scilit:
- Effects of process parameters on joint formation and tool wear behavior in friction stir welded TA5 alloyThe International Journal of Advanced Manufacturing Technology, 2022
- Corrosion evaluation of welded nickel aluminum bronze and manganese aluminum bronze in synthetic sea waterMaterials and Corrosion, 2022
- Microstructure and Mechanical Properties of Exothermic-Reaction-Assisted Friction-Stir-Welded Nickel-Aluminum Bronze AlloyJournal of Materials Engineering and Performance, 2019
- Strategies for numerical simulation of linear friction welding of metals: a reviewProduction Engineering, 2017
- Microstructural and Mechanical Properties of Friction Stir Welded Nickel-Aluminum Bronze (NAB) AlloyJournal of Materials Engineering and Performance, 2015
- 3D Finite Element Analysis of the Effect of Process Parameters on Linear Friction Welding of Mild SteelJournal of Materials Engineering and Performance, 2014
- Microstructural evolution of a TC11 titanium alloy during linear friction weldingJournal of Materials Science, 2010
- A microtexture investigation of recrystallization during friction stir processing of as-cast NiAl bronzeMetallurgical and Materials Transactions A, 2006
- Linear friction welding of Ti-6Al-4V: Processing, microstructure, and mechanical-property inter-relationshipsMetallurgical and Materials Transactions A, 2005
- Microstructural modification of as-cast NiAl bronze by friction stir processingMetallurgical and Materials Transactions A, 2004