Tribological Behavior of Aluminum Hybrid Nanocomposites Reinforced with Alumina and Graphene Oxide
Open Access
Abstract
Due to rapid technological advancements, the demand for lightweight materials with improved tribo-mechanical properties is continuously growing. The development of composite materials is one of the routes taken by researchers to meet these target properties. Aluminum (Al) is one of the most suitable materials used for developing composites for a wide range of applications because of its light weight, high conductivity, and high specific strength. In this study, aluminum hybrid nanocomposites with alumina (10 Vol% Al2O3) and varying loadings of graphene oxide (0.25, 0.5 and 1 wt% GO) were fabricated using the spark plasma sintering technique. The tribological properties of the developed hybrid composites were evaluated by conducting ball-on-disk wear tests at a normal load of 3N, with a sliding speed of 0.1 m/s, and for a sliding distance of 100 m. A 440C hardened stainless steel ball with a diameter of 6.3 mm and a hardness of 62 RC was used as a counterface. Scanning electron microscopy (SEM), elemental X-ray dispersive analysis (EDS), and optical profilometry were used to ascertain the involved wear mechanisms. The results revealed that Al-10 Vol%Vol% Al2O3-0.25 wt% GO hybrid nanocomposite showed an increase of 48% in the hardness, a reduction of 55% in the specific wear rate, and a reduction of 5% in COF compared with pure aluminum.Keywords
Funding Information
- Deanship of Scientific Research, King Fahd University of Petroleum & Minerals (IN151009)
This publication has 48 references indexed in Scilit:
- Microstructures and thermal properties of A356/SiCp composites fabricated by liquid pressing methodMaterials & Design (1980-2015), 2012
- In situ processing and aging behaviour of an aluminium/Al2O3 compositeMaterials & Design (1980-2015), 2011
- The effect of production parameters on microstructure and wear resistance of powder metallurgy Al–Al2O3 compositeMaterials & Design (1980-2015), 2011
- Effects of volume fraction of SiC particles on mechanical properties of SiC/Al compositesTransactions of Nonferrous Metals Society of China, 2009
- Effect of sub-micron Al2O3 concentration on dry wear properties of 6061 aluminum based compositeJournal of Materials Processing Technology, 2006
- Properties of alumina particulate reinforced aluminum alloy produced by pressure die castingMaterials & Design (1980-2015), 2006
- P/M aluminum matrix composites: an overviewJournal of Materials Processing Technology, 2003
- Effect of limited matrix–reinforcement interfacial reaction on enhancing the mechanical properties of aluminium–silicon carbide compositesActa Materialia, 2001
- Precipitation processes in Al-Cu-Mg alloys microalloyed with SiMetallurgical and Materials Transactions A, 2000
- Nonequilibrium Alloying of Graphite-Reinforced Aluminum Metal Matrix CompositesCorrosion, 1993