Mitigation of Secondary Flows and Pressure Side Bubble in Turbine Blade Passage Using Asymmetric Endwall Contouring: A Steady-State Analysis
- 20 November 2025
- journal article
- Published by IOP Publishing in Engineering Research Express
- Vol. 7 (4)
Abstract
In turbine passages, secondary vortices and pressure-side bubbles significantly contribute to aerodynamic losses and reduced blade efficiency issues that are critical in industrial gas turbine performance. Hence, it is very important to mitigate such losses to enhance overall turbine efficiency. Several research attempts have already been made to address this challenge; however, most studies have not focused explicitly on pressure-side bubble mitigation strategies. In the present investigation, an effort has been made to investigate the impact of endwall contouring in minimizing losses caused by secondary vortices, particularly focusing on pressure-side bubble formation. Experimental and numerical investigations are conducted on a low-speed blowing-type turbine cascade wind tunnel. The experimental study involves in-cascade testing, while numerical simulations are performed using ANSYS Reynolds-Averaged Navier-Stokes (RANS) equations with the Shear Stress Transport (SST) turbulence model. Three contouring configurations (EC1, EC2, and EC3) are compared against a non-profiled base case (BC). The results confirm that endwall curvature significantly alters secondary flow behavior and static pressure distribution. While EC1 and EC2 generated stagnant zones in the valleys, causing additional losses while the EC3 profile with optimized hump height and valley depth, redistributed pressure effectively. This effectively suppressed lateral flow migration and pressure-side bubble formation, which in turn enhanced overall turbine performance. In comparison to the base case, the EC3 design quantitatively reduced total pressure loss by 3.43%, proving its efficacy in improving aerodynamic performance.Keywords
This publication has 35 references indexed in Scilit:
- Experimental and numerical investigation on turbine flow control through integrating endwall contouring with section profiling at different Mach numbersAerospace Science and Technology, 2024
- Controlling secondary flow in high-lift low-pressure turbine using boundary-layer slot suctionChinese Journal of Aeronautics, 2023
- Effect of Incoming Vortex on Secondary Flows in Turbine Cascades with Planar and Non-Axisymmetric EndwallJournal of Thermal Science, 2023
- Effect of axial extension on parameterized endwall contour with incidence change for low-pressure turbine linear cascadeJournal of Mechanical Science and Technology, 2023
- Unsteady experimental and numerical investigation of aerodynamic performance in ultra-high-lift LPTChinese Journal of Aeronautics, 2020
- Effect of periodic wakes and a contoured endwall on secondary flow in a high-lift low-pressure turbine cascade at low Reynolds numbersComputers & Fluids, 2019
- Investigation of the comprehensive performance of turbine stator cascades with heating endwall fencesEnergy, 2019
- An investigation on the effect of pitchwise endwall design in a turbine cascade at different incidence anglesAerospace Science and Technology, 2017
- Tip-leakage flow loss reduction in a two-stage turbine using axisymmetric-casing contouringChinese Journal of Aeronautics, 2014
- Purge flow effect on aerodynamics performance in high-pressure turbine cascadeJournal of Mechanical Science and Technology, 2013