Design Optimization of the Bolted Connection Loaded Parallel to the Timber Grain for Masonry Building Retrofits
Open Access
- 10 February 2022
- journal article
- research article
- Published by North Atlantic University Union (NAUN) in International Journal of Mechanics
- Vol. 16, 6-14
Abstract
The experimental results of timber bolted connection tests for the purpose of optimizing the use of current design standard are presented. The test was conducted to investigate the structural performance of bolted connections loaded parallel to the timber grain. Both ductile and brittle failure modes were investigated to identify the governing parameters that affect the types of failures. The Meraka hardwood was chosen because it was found to be commonly used in the construction of the structural components of floor and roof diaphragms in Malaysia unreinforced masonry (URM) buildings. From this study, a wood database can be established for assisting the design engineers in developing the retrofitting technique of the building, especially the timber diaphragm joint part of the wall-diaphragm connections. Eighteen characteristics of steel-wood-steel (SWS) with a single row bolted joints were tested in tension, whereas ten specimens were prepared for each connection group. From the results obtained, it can be observed that the current timber design code is far too conservative compared to the optimized design proposed in this paper.Keywords
This publication has 16 references indexed in Scilit:
- Timber structures. Test methods. Determination of embedment strength and foundation values for dowel type fasteners2015
- Timber structures. Joints made with mechanical fasteners. General principles for the determination of strength and deformation characteristics2013
- Assessment Guidelines Of Wall-Diaphragm Connections For Masonry Buildings2013
- Federal Emergency Management Agency (FEMA)2012
- Intraosseous synovial sarcoma of the proximal femur: Case reportMalaysian Orthopaedic Journal, 2012
- Wood handbook: wood as an engineering material2010
- Bolted wood–steel and wood–steel–wood connections: verification of a new design approachCanadian Journal of Civil Engineering, 2001
- On the failure modes and strength of steel-wood-steel bolted timber connections loaded parallel-to-grainCanadian Journal of Civil Engineering, 2000
- Seismic evaluation of unreinforced masonry buildings — a state-of-the-art reportCanadian Journal of Civil Engineering, 1994
- State‐of‐the‐Art Report on Seismic Performance of Unreinforced Masonry BuildingsJournal of Structural Engineering, 1994