Effect of crystallization and packing pressure on the development of residual stresses on injection molded polypropylene samples
- 23 May 2022
- journal article
- research article
- Published by Springer Nature in Polymer Bulletin
- Vol. 80 (4) , 4355-4369
Abstract
No abstract availableKeywords
This publication has 18 references indexed in Scilit:
- Measurements of the thermal conductivity and thermal diffusivity of polymersPolymer Engineering & Science, 2003
- Residual thermal stresses in injection moldings of thermoplastics: A theoretical and experimental studyPolymer Engineering & Science, 2002
- The mechanism of crystallization of linear polyethylene, and its copolymers with octene, over a wide range of supercoolingsPolymer, 2001
- Shrinkage anisotropy in fiber reinforced injection molded productsPolymer Composites, 1998
- As‐molded shrinkage measurements on polystyrene injection molded productsPolymer Engineering & Science, 1998
- Prediction and analysis of nonisothermal crystallization of polymersJournal of Polymer Science Part B: Polymer Physics, 1997
- Residual thermal stresses in injection molded productsPolymer Engineering & Science, 1996
- Nonisothermal crystallization kinetics of poly(etheretherketone) (PEEK)Polymer Engineering & Science, 1989
- Effect of residual stress on crack propagation in MDPE pipesJournal of Materials Science, 1987
- The influence of residual stresses and orientation on the properties of amorphous polymersPolymer Engineering & Science, 1980