Effect of liner and porcelain application on zirconia surface structure and composition
Open Access
- 22 July 2016
- journal article
- research article
- Published by Springer Nature in International Journal of Oral Science
- Vol. 8 (3) , 164-171
Abstract
The purpose of this study was to determine if there is an effect of liner and porcelain application (layering and pressing techniques) on the surface of yttria-stabilized tetragonal zirconia polycrystals (Y-TZP), which were exposed to permutations of liner, layered porcelain, and pressed porcelain. Scanning electron microscope (SEM)/energy dispersive spectroscope (EDS) was used to identify changes in composition and microstructure after removing liner and porcelain with hydrofluoric acid. Simulated aging was also conducted to determine the effect of liner and porcelain on low-temperature degradation. The control group had a typical equiaxed grain structure, referred to as unaffected. When covered with liner or porcelain, some areas changed in structure and composition and were termed affected. The frequency of affected structure decreased when liner was covered with either layered porcelain or pressed porcelain. There were statistical differences (Pm/m), unaffected=69% (4%), layered porcelain without liner: affected=59% (3%), unaffected=65% (3%)) and oxygen (layered porcelain with liner: affected=35% (2%), unaffected=26% (4%), layered porcelain without liner: affected=35% (3%), unaffected=30% (2%)). However, there were statistical differences (P<0.05) in the composition for zirconium and oxygen of the aged layered porcelain without liner only. The liner should not be used before porcelain application, especially when using the layering technique for zirconia restorations. Furthermore, pressing should be considered the technique of choice over layering.Keywords
This publication has 35 references indexed in Scilit:
- Influence of zirconia surface treatment on veneering porcelain shear bond strength after cyclic loadingThe Journal of Prosthetic Dentistry, 2014
- Effect of zirconia surface treatment on zirconia/veneer interfacial toughness evaluated by fracture mechanics methodJournal of Dentistry, 2014
- Interfacial adhesion of zirconia/veneer bilayers with different thermal characteristicsDental Materials Journal, 2014
- Effect of sandblasting on surface roughness of zirconia-based ceramics and shear bond strength of veneering porcelainDental Materials Journal, 2014
- Digital veneering system enhances microtensile bond strength at zirconia coreveneer interfaceDental Materials Journal, 2014
- Effect of thermal expansion mismatch on the Y-TZP/veneer interfacial adhesion determined by strain energy release rateJournal of Prosthodontic Research, 2012
- Shear bond strengths of pressed and layered veneering ceramics to high-noble alloy and zirconia coresThe Journal of Prosthetic Dentistry, 2011
- Influence of cooling rate on zirconia/veneer interfacial adhesionActa Biomaterialia, 2010
- Compatibility of machined Ce-TZP/Al2O3 nanocomposite and a veneering ceramicDental Materials, 2007
- Microstructural and crystallographic surface changes after grinding zirconia‐based dental ceramicsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005