High-speed diode laser measurements of temperature and water vapor concentration in the intake manifold of a diesel engine
- 30 January 2014
- journal article
- research article
- Published by SAGE Publications in International Journal of Engine Research
- Vol. 15 (7) , 773-788
Abstract
A diode laser–based sensor system, utilizing absorption spectroscopy, has been developed to provide high-speed (5 kHz) simultaneous measurements of temperature and water vapor concentration in the intake manifold of a diesel engine. A fiber-coupled 1.38 µm diode laser was used to probe absorption transitions of water vapor for the high-speed gas temperature and water vapor concentration measurements. Water vapor readily absorbs in the near-infrared region, and distributed feedback diode lasers as well as optics for near-infrared region are readily available because of their use in telecommunications. Fresh charge and combustion products are the only sources of water vapor in an engine’s gas exchange path; therefore, water vapor concentration at various locations in the intake manifold is a useful measure of the recirculated exhaust gas distribution in the intake manifold. Measurements were performed on a six-cylinder Cummins diesel engine using compact fiber optic–coupled connectors. The chosen water vapor absorption transitions provided good absorption strength even without exhaust gas recirculation and water vapor concentration of as low as 0.7 vol.% could be measured with a signal-to-noise ratio of ∼35 leading to very good spectral fits. The sensor output was within 2% of the thermocouple readings and within 10% of the water vapor concentration derived from mean CO2 analyzer measurements for steady-state engine operation. For transient engine operation, the time response of the diode laser sensor was shown to be vastly superior to that of the installed thermocouple and the gas analyzer system.Keywords
This publication has 41 references indexed in Scilit:
- High-speed PIV and LIF imaging of temperature stratification in an internal combustion engineProceedings of the Combustion Institute, 2013
- Control-oriented premixed charge compression ignition combustion timing model for a diesel engine utilizing flexible intake valve modulationInternational Journal of Engine Research, 2012
- Simultaneous high-speed visualization of soot luminosity and OH∗ chemiluminescence of alternative-fuel combustion in a HSDI diesel engine under realistic operating conditionsCombustion and Flame, 2012
- Physically based volumetric efficiency model for diesel engines utilizing variable intake valve actuationInternational Journal of Engine Research, 2011
- Analysis of the temporal flame kernel development in an optically accessible IC engine using high-speed OH-PLIFApplied Physics B, 2010
- Investigation of charge preparation strategies for controlled premixed charge compression ignition combustion using a variable pressure injection systemInternational Journal of Engine Research, 2010
- Diode-laser-based ultraviolet-absorption sensor for high-speed detection of the hydroxyl radicalOptics Letters, 2005
- Combustion exhaust measurements of nitric oxide with an ultraviolet diode-laser-based absorption sensorApplied Optics, 2005
- Diode laser absorption sensors for gas-dynamic and combustion flowsMeasurement Science and Technology, 1998
- An experimental study on premixed-charge compression ignition gasoline engineJSAE Review, 1995