The «KT model» of cavitation mass transfer for simulation in ANSYS CFX
- 16 September 2020
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-11
Abstract
The aim of the research is improvement of numerical cavitation models for simulation of hydrodynamic cavitation. The methods of development of a new dynamic component for a numerical model of cavitation mass transfer is presented in the paper. Application of the new method resulted in a new dynamic component for numerical model of cavitation mass transfer, which takes into account fluid viscosity in Rayleigh-Plesset equation. The new dynamic component has become the basis for the new numerical model of cavitation mass transfer [14]. The new model was called the Konstantinov-Tselischev model or the KT model. The KT model was verified by experimental researches of the effect of cavitation in ajet element “pipe-pipe”. The results of simulation showed that the KT model of cavitation mass transfer can simulate cavitation in thejet pipes with the difference between results of simulation and experiment not exceeding 2,5% and visualizing a cavitation zone more adequate.Keywords
This publication has 6 references indexed in Scilit:
- An Assessment of Computational Fluid Dynamics Cavitation Models Using Bubble Growth Theory and Bubble Transport ModelingJournal of Fluids Engineering, 2019
- Automated Rig for Diagnostics and Testing of Hydraulic EquipmentAutomation and Remote Control, 2019
- An efficient calibration approach for cavitation model constants based on OpenFOAM platformJournal of Marine Science and Technology, 2018
- Analytical Calculation of Hydraulic Characteristics of Jet-cavitation Fluid Mass Flow StabilizersProcedia Engineering, 2017
- Cavitation modeling for steady-state CFD simulationsIOP Conference Series: Earth and Environmental Science, 2016
- Review of numerical models of cavitating flows with the use of the homogeneous approachArchives of Thermodynamics, 2016