IMPACT OF BLENDING OF FRYING OILS ON VISCOSITY AND HEAT TRANSFER COEFFICIENT AT ELEVATED TEMPERATURES
- 25 January 2010
- journal article
- Published by Wiley in Journal of Food Process Engineering
- Vol. 33 (1) , 144-161
Abstract
In the present work, the effect of binary blending of five frying oils on kinematic viscosity (ν) and convective heat transfer coefficient (h) was studied at elevated temperatures (170, 180 and 190C). A Cannon Ubbelhode calibrated capillary viscometer (Cannon Instrument Company, State College, PA) in a custom‐designed and fabricated convective air bath heater and a highly conductive cylindrical metal transducer were used for generatingνand h data, respectively. The value ofνdecreased from 3.617 × 10‐6 to 2.062 × 10‐6 m2 s‐1, and h increased from 221.0 to 301.2 Wm‐2 C‐1 by increasing the aforementioned oil temperatures. A good correlation betweenν (R2 > 0.996) or h (R2 > 0.987) of these frying oils and their selected binary blends with the previously mentioned temperature range was observed. Significant difference (P < 0.05) was found between different levels of parameters when treatments were compared using Tukey's test.PRACTICAL APPLICATIONS: In food engineering applications, the physical properties of foods play an important role in the analysis of process parameters and in the design and fabrication of processing equipment. Determination of kinematic viscosity and convective heat transfer coefficients of frying oils and their selected blends at elevated temperatures are useful from an industrial point of view. In the present work, the effect of blending different edible oils on the kinematic viscosity and convective heat transfer coefficients at elevated temperatures was studied. Because selected blended oils provided lower levels of viscosities and higher levels of heat transfer coefficients, these results may be an attractive proposition in improving the quality of fried products and cost‐effectiveness in the fried food industry.Keywords
This publication has 23 references indexed in Scilit:
- VISCOSITY ESTIMATION OF VEGETABLE OILS BASED ON THEIR FATTY ACID COMPOSITIONJournal of Food Lipids, 2002
- INFLUENCE of OIL TEMPERATURE ON CONVECTIVE HEAT TRANSFER DURING IMMERSION FRYINGJournal of Food Processing and Preservation, 2000
- A METHOD FOR DETERMINING THE CONVECTIVE HEAT TRANSFER COEFFICIENT DURING IMMERSION FRYINGJournal of Food Process Engineering, 1999
- Total frying-use time effects on soybean-oil deterioration and on tortilla chip qualityInternational Journal of Food Science and Technology, 1996
- SIMULTANEOUS HEAT and MASS TRANSFER DURING the DEEP FAT FRYING of TORTILLA CHIPSJournal of Food Process Engineering, 1995
- VISCOSITY and SURFACE TENSION of CORN OIL AT FRYING TEMPERATURESJournal of Food Processing and Preservation, 1995
- Effect of deep-fat frying on fat oxidation in soybean oilInternational Journal of Food Sciences and Nutrition, 1995
- Optimization of deep-fat frying operationsTrends in Food Science & Technology, 1991
- Development and evaluation of a novel sensor for the in situ assessment of frying oil qualityFood Control, 1990
- The Reaction Rate Theory of Viscosity and Some of its ApplicationsJournal of Applied Physics, 1938