Fast Fluorescence-Based Microfluidic Method for Measuring Minimum Miscibility Pressure of CO2 in Crude Oils
Authors:
Open Access
- 10 February 2015
- journal article
- research article
- Published by American Chemical Society (ACS) in Analytical Chemistry
- Vol. 87 (6) , 3160-3164
Abstract
Carbon capture, storage, and utilization has emerged as an essential technology for near-term CO2 emission control. The largest CO2 projects globally combine storage and oil recovery. The efficiency of this process relies critically on the miscibility of CO2 in crude oils at reservoir conditions. We present a microfluidic approach to quantify the minimum miscibility pressure (MMP) that leverages the inherent fluorescence of crude oils, is faster than conventional technologies, and provides quantitative, operator-independent measurements. To validate the approach, synthetic oil mixtures of known composition (pentane, hexadecane) are tested and MMP values are compared to reported values. Results differ by less than 0.5 MPa on average, in contrast to comparison between conventional methods with variations on the order of 1–2 MPa. In terms of speed, a pressure scan for a single MMP measurement required less than 30 min (with potential to be sub-10 min), in stark contrast to days or weeks with existing approaches. The method is applied to determine the MMP for Pennsylvania, West Texas, and Saudi crudes. Importantly, our fluorescence-based approach enables rapid, automated, operator-independent measurement of MMP as needed to inform the world’s largest CO2 projects.Keywords
This publication has 62 references indexed in Scilit:
- Steam-on-a-chip for oil recovery: the role of alkaline additives in steam assisted gravity drainageLab on a Chip, 2013
- Aquifer-on-a-Chip: understanding pore-scale salt precipitation dynamics during CO2 sequestrationLab on a Chip, 2013
- Tuning bubbly structures in microchannelsBiomicrofluidics, 2012
- Formation of Bubbles in a Multisection Flow‐Focusing JunctionSmall, 2010
- In situ characterization of microdroplet interfacial properties in digital microfluidic systemsLab on a Chip, 2010
- Design and Evaluation of a Passive Alcove-Based Microfluidic MixerAnalytical Chemistry, 2009
- Determination of CO2 Minimum Miscibility Pressure from Measured and Predicted Equilibrium Interfacial TensionsIndustrial & Engineering Chemistry Research, 2008
- Control and Measurement of the Phase Behavior of Aqueous Solutions Using MicrofluidicsJournal of the American Chemical Society, 2007
- A Very Simple Multiple Mixing Cell Calculation To Compute the Minimum Miscibility Pressure Whatever the Displacement MechanismIndustrial & Engineering Chemistry Research, 1998
- Measuring CO2 Minimum Miscibility Pressures: Slim-Tube or Rising-Bubble Method?Energy & Fuels, 1996