EMI mitigation with lossy material at 10 GHz
Authors:
- 1 August 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 2158110X,p. 150-154
Abstract
In this paper, absorber material is utilized to mitigate an EMI problem in real hardware. For a complex and large system, identification of the source location is the first problem which must be solved to achieve electromagnetic interference (EMI) mitigation. Emission Source Microscopy (ESM) provides a powerful tool for locating the sources of radiation in GHz range on a printed circuit board (PCB). Once the source is identified, a suitable volume of the absorber material is placed on the source location to effectively reduce the radiated power at the frequency of interest. Further measurements of the total radiated power in a reverberation chamber are also performed to validate the EMI reduction method with the absorber material.Keywords
This publication has 7 references indexed in Scilit:
- Optimum Two-Dimensional Uniform Spatial Sampling for Microwave SAR-Based NDE Imaging SystemsIEEE Transactions on Instrumentation and Measurement, 2011
- Susceptibility Scanning as a Failure Analysis Tool for System-Level Electrostatic Discharge (ESD) ProblemsIEEE Transactions on Electromagnetic Compatibility, 2008
- The PCB level ESD immunity study by using 3 dimension ESD scan system2004
- Three-dimensional millimeter-wave imaging for concealed weapon detectionIEEE Transactions on Microwave Theory and Techniques, 2001
- Radiated Power Measurements in Reverberation Chambers2000
- An overview of near-field antenna measurementsIEEE Transactions on Antennas and Propagation, 1986
- A method of locating defective elements in large phased arraysProceedings of the IEEE, 1971