Optimization of injection parameters for mechanical properties of specimens with weld line of polypropylene using Taguchi method
Author:
- Babur OzcelikBOBabur Ozcelik
- 1 October 2011
- journal article
- Published by Elsevier in International Communications in Heat and Mass Transfer
- Vol. 38 (8) , 1067-1072
Abstract
No abstract availableKeywords
This publication has 7 references indexed in Scilit:
- Effect of cavity surface coating on mold temperature variation and the quality of injection molded partsInternational Communications in Heat and Mass Transfer, 2009
- Investigation on the weldline strength of thin-wall injection molded ABS partsInternational Communications in Heat and Mass Transfer, 2007
- Reducing the effects of weldlines on appearance of plastic products by Taguchi experimental methodThe International Journal of Advanced Manufacturing Technology, 2006
- Evaluation of mechanical properties of adjacent flow weldlinePolymer Engineering & Science, 2005
- Effects of geometry and injection‐molding parameters on weld‐line strengthPolymer Engineering & Science, 2005
- An experimental matrix design to optimize the weldline strength in injection molded partsPolymer Engineering & Science, 2000
- Effect of processing on weld line strength in five thermoplasticsPolymer Engineering & Science, 1997