Evaluation of two constitutive modeling approaches for finite element simulation of ballistic impact of varying thickness monolithic aluminum plates by steel spheres
- 23 August 2024
- journal article
- research article
- Published by SAGE Publications in International Journal of Protective Structures
- Vol. 16 (3) , 707-733
Abstract
A comparison of material models for numerical simulations of ballistic impact is performed to study a physics motivated model’s efficacy in overcoming the limitations of traditional empirical models in accurately capturing dynamic deformation and failure mechanisms. The ballistic impact of Aluminum 7085-T711 alloy plates struck by hardened steel projectiles has been modeled using Johnson-Cook (JC) and an Internal State Variable (ISV) constitutive model, DMG, embedded in Abaqus Explicit and EPIC finite element simulations. Both constitutive models show good quantitative agreement with experimental perforation velocity and residual projectile velocity characteristics over the range of plate thicknesses tested. For thin plates, both experiments and numerical calculations show transition from large plastic deformation to lower energy perforation modes (localized fracture) for increasing impact velocity. The ISV model tends to accurately predict the shear-plug dominated perforation modes for all target thicknesses and impact velocities, while the JC model inaccurately predicts target fragmentation at impact velocities significantly greater than a given plate’s ballistic limit. ISV model results show that void nucleation is more influential on damage evolution and fracture than void growth for Al 7085-T711 under ballistic impact loads, however each contributes to the fracture mechanism.Keywords
This publication has 49 references indexed in Scilit:
- Penetration modeling of ultra‐high performance concrete using multiscale meshfree methodsInternational Journal for Numerical and Analytical Methods in Geomechanics, 2019
- Computational modelling of impact damage in brittle materialsInternational Journal of Solids and Structures, 1996
- Equation of State1993
- An internal variable model of viscoplasticityInternational Journal of Engineering Science, 1984
- Analysis of the cup-cone fracture in a round tensile barActa Metallurgica, 1984
- The mechanics of penetration of projectiles into targetsInternational Journal of Engineering Science, 1978
- Stress-strain data obtained at high rates using an expanding ringExperimental Mechanics, 1969
- Plate impact and perforation by projectilesExperimental Mechanics, 1965
- Theorie des festen Zustandes einatomiger ElementeAnnalen der Physik, 1912
- Zur kinetischen Theorie der einatomigen KörperAnnalen der Physik, 1903