CAE applications in a thermoforming mould design
Open Access
- 1 February 2016
- conference paper
- Published by IOP Publishing in IOP Conference Series: Materials Science and Engineering
- Vol. 114 (1) , 012012
Abstract
Preparation of honeycomb layer is a critical step for successful fabrications of thermoformed based sandwiched structures. This paper deals with an initial investigation on the rapid manufacturing process of corrugated sheet with 120° dihedral angles. Time history of local displacements and thickness, assuming viscous dominated material model for a 1mm thick thermoformable material, was computed by using ANSYS® Polyflow solver. The quality of formed surfaces was evaluated for selection of mould geometry and assessment of two common variants of thermoforming process. Inadequate mesh refinement of a membrane elements produces satisfactorily detailing and incomplete forming. A perfectly uniform material distribution was predicted using drape forming process. However, the geometrical properties of vacuum formed part are poorly distributed and difficult to control with increasing inflation volumes. Details of the discrepancies and the contributions of the CAE tool to complement traditional trial and error methodology in the process and design development are discussed.Keywords
This publication has 6 references indexed in Scilit:
- CAE applications in a thermoforming mould designIOP Conference Series: Materials Science and Engineering, 2016
- Simulation of the plug-assisted thermoforming of polypropylene using a large strain thermally coupled constitutive modelJournal of Materials Processing Technology, 2013
- Understanding Thermoforming2008
- Computational modelling of thermoforming processes in the case of finite viscoelastic materialsComputer Methods in Applied Mechanics and Engineering, 2006
- Determination of critical material parameters for numerical simulation of acrylic sheet formingJournal of Materials Science, 2005
- Dynamic finite element analysis of nonlinear isotropic hyperelastic and viscoelastic materials for thermoforming applicationsPolymer Engineering & Science, 2004