A Self-Established “Machining-Measurement-Evaluation” Integrated Platform for Taper Cutting Experiments and Applications
Open Access
- 4 August 2021
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 12 (8) , 929
Abstract
Taper-cutting experiments are important means of exploring the nano-cutting mechanisms of hard and brittle materials. Under current cutting conditions, the brittle-ductile transition depth (BDTD) of a material can be obtained through a taper-cutting experiment. However, taper-cutting experiments mostly rely on ultra-precision machining tools, which have a low efficiency and high cost, and it is thus difficult to realize in situ measurements. For taper-cut surfaces, three-dimensional microscopy and two-dimensional image calculation methods are generally used to obtain the BDTDs of materials, which have a great degree of subjectivity, leading to low accuracy. In this paper, an integrated system-processing platform is designed and established in order to realize the processing, measurement, and evaluation of taper-cutting experiments on hard and brittle materials. A spectral confocal sensor is introduced to assist in the assembly and adjustment of the workpiece. This system can directly perform taper-cutting experiments rather than using ultra-precision machining tools, and a small white light interference sensor is integrated for in situ measurement of the three-dimensional topography of the cutting surface. A method for the calculation of BDTD is proposed in order to accurately obtain the BDTDs of materials based on three-dimensional data that are supplemented by two-dimensional images. The results show that the cutting effects of the integrated platform on taper cutting have a strong agreement with the effects of ultra-precision machining tools, thus proving the stability and reliability of the integrated platform. The two-dimensional image measurement results show that the proposed measurement method is accurate and feasible. Finally, microstructure arrays were fabricated on the integrated platform as a typical case of a high-precision application.Keywords
Funding Information
- National Key Research and Development Program of China (2017YFA0701200)
- Science Challenge Project (TZ2018006-0203-01)
- Tianjin Municipal Science and Technology Program (19JCZDJC39100)
- National Postdoctoral Program for Innovative Talents of China (BX20190230)
This publication has 23 references indexed in Scilit:
- Theoretical study on brittle–ductile transition behavior in elliptical ultrasonic assisted grinding of hard brittle materialsPrecision Engineering, 2016
- Influence of cutting parameters on the ductile-brittle transition of single-crystal calcium fluoride during ultra-precision cuttingThe International Journal of Advanced Manufacturing Technology, 2016
- Prediction of critical cutting depth for ductile-brittle transition in ultrasonic vibration assisted grinding of optical glassesThe International Journal of Advanced Manufacturing Technology, 2016
- Nanometric cutting in a scanning electron microscopePrecision Engineering, 2015
- Manufacturing and measurement of freeform opticsCIRP Annals, 2013
- Fundamental investigation of subsurface damage in single crystalline silicon caused by diamond machiningPrecision Engineering, 2009
- Predictive modeling of transition undeformed chip thickness in ductile-regime micro-machining of single crystal brittle materialsJournal of Materials Processing Technology, 2009
- A study on mechanism of nano-cutting single crystal siliconJournal of Materials Processing Technology, 2007
- Modelling and experimental investigation on nanometric cutting of monocrystalline siliconInternational Journal of Machine Tools and Manufacture, 2005
- Ductile-Regime Grinding: A New Technology for Machining Brittle MaterialsJournal of Engineering for Industry, 1991