Variation of Microstructural and Mechanical Properties With Respect to Polarity in Shielded Metal Arc Welding of Mild Steel
- 1 April 2019
- journal article
- research article
- Published by Ram Arti Publishers in International Journal of Mathematical, Engineering and Management Sciences
- Vol. 4 (2) , 521-530
Abstract
Welding has been done by taking mild steel as work piece material in shielded metal arc welding (SMAW) process. Material thickness and current were considered as input parameters. Joining of metals has been completed in two ways. In first process double pass welding has been done in which 1st pass was in reverse polarity and the second pass was in straight polarity and in the 2nd process both the passes of welding were completed with straight polarity. The comparison of microstructure and impact toughness has been investigated. It was found that more amount of heat was generated in the 2nd process as compared to the 1st process. Therefore, growths of grains in heat affected zone occurred and maximum growth occurred in 2nd than 1st process. Impact strength increased with decrease in current value and increase in material thickness respectively. The impact strength values for 1st process welding were relatively less as compared to 2nd process.Keywords
This publication has 9 references indexed in Scilit:
- Stress Concentration Studies in Flat Plates with Rectangular Cut-Outs Using Finite Element MethodInternational Journal of Mathematical, Engineering and Management Sciences, 2019
- A Comparison of Start-Up Demonstration Test Procedures Based on a Combinatorial ApproachInternational Journal of Mathematical, Engineering and Management Sciences, 2018
- Parametric Bootstrap Methods for Estimating Model Parameters of Non-homogeneous Gamma ProcessInternational Journal of Mathematical, Engineering and Management Sciences, 2018
- Study of hardness of the weld bead formed by partial hybrid welding by metal inert gas welding and submerged arc welding at three different heat inputsMaterials Today: Proceedings, 2018
- Diffusion of Innovations: Patenting or StandardizationInternational Journal of Mathematical, Engineering and Management Sciences, 2017
- Process parameter optimization of gas metal arc welding on IS:2062 mild steel using response surface methodologyJournal of Manufacturing Processes, 2017
- Effect of Welding Parameters on Tensile & Yield Strength of IS 2062 grade Steel Using Design of Experiment ApproachMaterials Today: Proceedings, 2017
- Influence of Heat Input and PWHT on the Microstructure and Mechanical Properties in Dissimilar (IS2062-EN8) Welded JointsProcedia Computer Science, 2016
- Effect of welding variables on mechanical properties of low carbon steel welded jointAdvances in Production Engineering & Management, 2014