Open Access
- 12 March 2025
- other
- Published by Copernicus GmbH
- Vol. 2024, 1-25
Abstract
Wind turbines generate significant seismic noise and interfere with sensitive instruments, such as permanent and temporary seismic sensors installed nearby, hampering their detection capabilities. This study investigates the seismic noise emission from one of Italy’s largest wind farms, consisting of 69 turbines (2 MW each), located in northeastern Sardinia. Characterizing the noise emission from this wind farm is of particular importance due to its proximity to the Italian candidate site for hosting the Einstein Telescope, the third-generation observatory for gravitational waves. We run a passive seismic experiment (WINES, 'Wind turbIne Noise assEsSment in the Italian site candidate for Einstein Telescope') using a linear array of nine broadband stations, installed at increasing distances from the wind farm. Spectral analysis, based on the retrieval of spectrograms and power spectral densities at all stations, shows a significant increase in noise amplitude when the wind farm is in operation. The reconstruction of noise polarization points out that the noise wavefield originates from a direction consistent with the wind farm’s location. We recognize four dominant fixed spectral peaks at 3.4, 5.0, 6.8, and 9.5 Hz, corresponding to the modes of vibration of the wind turbine towers. While decreasing in amplitude with distance, the 3.4 Hz peak remains detectable up to 13 km from the nearest turbine. Assuming an amplitude decay model of the form r -α, where r is the distance, we estimate a damping factor of α∼2, that remains rather constant for each of the four main peaks, an observation that we relate to the good geomechanical characteristics of the local terrain, consisting of granitoid rocks. To better evaluate the possible impact of the wind farm noise emission on the Einstein Telescope, we also analyze the seismic data from two permanent stations bordering the ET candidate site area, each equipped with both a surface and borehole sensor at approximately 250 m depth. Power spectral density analysis for the surface and borehole sensors exhibits similar results and very low noise levels. When the wind farm operates at full capacity, the borehole sensors remain unaffected by the emitted seismic noise, highlighting the significant noise suppression at depth. However, small residual spectral peaks at 3.4 Hz and between 4–6 Hz remain detectable.Keywords
This publication has 42 references indexed in Scilit:
- Handbook of Gravitational Wave Astronomy2022
- Wind turbine induced seismic signals: the large‐scale SMARTIE1 experiment and a concept to define protection radii for recording stationsNear Surface Geophysics, 2020
- The Italian earthquake catalogue CPTI15Bulletin of Earthquake Engineering, 2020
- Simultaneous identification of wind turbine vibrations by using seismic data, elastic modeling and laser Doppler vibrometryWind Energy, 2020
- Handbook of Gravitational Wave Astronomy2020
- Erschütterungsemissionen von WindenergieanlagenStahlbau, 2019
- Influence of wind turbines on seismic stations in the upper rhine graben, SW GermanyJournal of Seismology, 2017
- Assessing the seismic wavefield of a wind turbine using polarization analysisWind Energy, 2017
- Näherungsweise Integration der Feldgleichungen der Gravitation2005
- The Levenberg-Marquardt algorithm: Implementation and theory1978