Oxidation of arc-evaporated Al1−xCrxN coatings
- 1 July 2007
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 25 (4) , 711-720
Abstract
The recently introduced Al 1 − x Cr x N coatings are characterized by superior thermal stability and oxidation resistance. Although several studies on the microstructure and mechanical properties of these coatings have been published, the oxidation behavior and mechanisms were only investigated for Al 1 − x Cr x N with Cr ∕ Al ratio bigger than 1. Within this work, the oxidation of arc-evaporated Al 1 − x Cr x N coatings was investigated as a function of the Al content. Coatings were deposited onto cemented carbide substrates using an industrial-scale arc evaporation system (Balzers rapid coating system) and alloyed Al ∕ Cr targets yielding Al 1 − x Cr x N coatings ranging from x = 0.29 to x = 0.79 . Heat treatments in air were conducted in the temperature range between 900 and 1100 ° C . For comparison, samples were also annealed in Ar between 900 and 1200 ° C . Elemental distributions within the coating and the oxide layers were determined by secondary ion mass spectroscopy. After annealing in Ar, Cr was found to segregate to the coating surface following the decomposition of the face-centered cubic Al 1 − x Cr x N phase into hcp AlN and, under release of N 2 , Cr 2 N and later on Cr. Simultaneously, Al depletion was observed within the Cr enriched near-surface zone. In contrast, the decomposition of the cubic Al 1 − x Cr x N phase is severely hindred during annealing in air. Outward diffusion of Cr and Al, N depletion, and inward diffusion of O were observed, manifesting diffusion mechanisms depending on the initial coating composition. A protective mixed Cr 2 O 3 – Al 2 O 3 scale, at the coating surface mainly dominated by Cr 2 O 3 , was formed for all coating compositions investigated. This protective oxide scale prevents the decomposition of the cubic Al 1 − x Cr x N phase during high temperature exposure.Keywords
This publication has 12 references indexed in Scilit:
- Thermal stability of Al–Cr–N hard coatingsScripta Materialia, 2006
- Investigation of the properties of Al1−xCrxN coatings prepared by cathodic arc evaporationSurface and Coatings Technology, 2005
- Oxidation resistance of Cr1−XAlXN and Ti1−XAlXN filmsSurface and Coatings Technology, 2003
- Microhardness and lattice parameter of Cr1−xAlxN filmsJournal of Vacuum Science & Technology A, 2002
- Thermal stability of nitride thin filmsVacuum, 2000
- (Cr:Al)N coatings deposited by the cathodic vacuum are evaporationSurface and Coatings Technology, 1998
- Phase transition of pseudobinary Cr–Al–N films deposited by magnetron sputtering methodSurface and Coatings Technology, 1997
- Vacuum arc coatings for tools: Potential and applicationSurface and Coatings Technology, 1995
- Properties of arc-evaporated CrN and (Cr, Al)N coatingsSurface and Coatings Technology, 1991
- Oxidation behavior of CrNx and (Cr,Al)Nx hard coatingsMaterials and Corrosion, 1990