Rubidium distribution at atomic scale in high efficient Cu(In,Ga)Se2 thin-film solar cells
Open Access
- 5 March 2018
- journal article
- conference paper
- Published by AIP Publishing in Applied Physics Letters
- Vol. 112 (10) , 103105
Abstract
The introduction of a rubidium fluoride post deposition treatment (RbF-PDT) for Cu(In,Ga)Se2 (CIGS) absorber layers has led to a record efficiency up to 22.6% for thin-film solar cell technology. In the present work, high efficiency CIGS samples with RbF-PDT have been investigated by atom probe tomography (APT) to reveal the atomic distribution of all alkali elements present in CIGS layers and compared with non-treated samples. A Scanning Electron Microscopy Dual beam station (Focused Ion Beam–Gas Injection System) as well as Transmission Kikuchi diffraction is used for atom probe sample preparation and localization of the grain boundaries (GBs) in the area of interest. The analysis of the 3D atomic scale APT reconstructions of CIGS samples with RbF-PDT shows that inside grains, Rb is under the detection limit, but the Na concentration is enhanced as compared to the reference sample without Rb. At the GBs, a high concentration of Rb reaching 1.5 at. % was found, and Na and K (diffusing from the glass substrate) are also segregated at GBs but at lower concentrations as compared to Rb. The intentional introduction of Rb leads to significant changes in the chemical composition of CIGS matrix and at GBs, which might contribute to improve device efficiency.Keywords
Funding Information
- EC | Horizon 2020 Framework Programme (641004)
This publication has 18 references indexed in Scilit:
- Interfacial Alkali Diffusion Control in Chalcopyrite Thin-Film Solar CellsACS Applied Materials & Interfaces, 2014
- Potassium-induced surface modification of Cu(In,Ga)Se2 thin films for high-efficiency solar cellsNature Materials, 2013
- Atom Probe Tomography Studies on the Cu(In,Ga)Se2 Grain BoundariesJournal of Visualized Experiments, 2013
- CIGS thin-film solar cells and modules on enamelled steel substratesSolar Energy Materials and Solar Cells, 2012
- Atom probe study of sodium distribution in polycrystalline Cu(In,Ga)Se2 thin filmActa Materialia, 2010
- Toward a laser assisted wide‐angle tomographic atom‐probeSurface and Interface Analysis, 2007
- Strategies for fabricating atom probe specimens with a dual beam FIBUltramicroscopy, 2005
- Anomalous Grain Boundary Physics in Polycrystalline: The Existence of a Hole BarrierPhysical Review Letters, 2003
- Measurement of the Gibbsian interfacial excess of solute at an interface of arbitrary geometry using three-dimensional atom probe microscopyMaterials Science and Engineering: A, 2002
- An atomistic study of tilt grain boundaries with substitutional impuritiesActa Metallurgica, 1982