The influence of bedding interface strength on the vertical propagation of hydraulic fractures
Authors:
- Dong XiongDXDong Xiong
- Xinfang MaXMXinfang Ma
- Shicheng ZhangSZShicheng Zhang
- Jiayuan HeJHJiayuan He
- 1 May 2024
- journal article
- research article
- Published by AIP Publishing in Physics of Fluids
- Vol. 36 (5)
Abstract
Bedding interfaces in unconventional oil and gas may influence the vertical propagation path of hydraulic fractures. In this article, the cohesive elements were used to describe the tensile and shear damage of bedding interfaces. The vertical propagation law of hydraulic fractures under different stress, bedding interface tensile strength, and shear strength conditions was calculated. The simulation result revealed three types of hydraulic fractures: “H”-shaped, “fishbone”-shaped, and “I”-shaped fractures. The large vertical stress can cause difficulties in damaging bedding interfaces. When the vertical stress difference lies between 0 and 5 MPa, complex fishbone-shaped fractures can easily form. However, when the vertical stress exceeds 5 MPa, “I”-shaped fractures are more likely to occur. In case the vertical stress difference is less than 0 MPa, hydraulic fractures may encounter obstacles in crossing the bedding interface, resulting in the formation of “H”-shaped fractures. A larger tensile strength of the bedding interface will promote hydraulic fractures to pass through the bedding interface and make it easier to form “I”-shaped fractures, promoting the growth of fracture height, which promotes fracture height growth. On the other hand, a low shear strength in the bedding interface can cause shear slip, resulting in the formation of “H”-shaped fractures, which inhibits the growth of fracture height. Tensile shear mixed damage typically happens at the bedding interface. This type of damage can restrict the vertical propagation of hydraulic fractures, but it can also make the fractures more complicated.Keywords
Funding Information
- Research on Deep Coalbed Methane Drilling and Stimulation Technology (P23207)
This publication has 35 references indexed in Scilit:
- A hydro-mechanical-damage fully coupled cohesive phase field model for complicated fracking simulations in poroelastic mediaComputer Methods in Applied Mechanics and Engineering, 2022
- Effect of joint parameters on fracturing behavior of shale in notched three-point-bending test based on discrete element modelEngineering Fracture Mechanics, 2019
- Numerical investigation of the interactions between hydraulic fracture and bedding planes with non-orthogonal approach angleEngineering Fracture Mechanics, 2018
- Numerical investigation of hydraulic fracture propagation in a layered reservoir using the cohesive zone methodEngineering Fracture Mechanics, 2017
- Experimental Study of Mode-I Fracture Toughness for Layered Shale Based on Two ISRM-Suggested MethodsRock Mechanics and Rock Engineering, 2017
- Fracture toughness anisotropy in shaleJournal of Geophysical Research: Solid Earth, 2016
- The interaction of propagating opening mode fractures with preexisting discontinuities in shaleJournal of Geophysical Research: Solid Earth, 2014
- An implicit level set method for modeling hydraulically driven fracturesComputer Methods in Applied Mechanics and Engineering, 2008
- Measurement of mixed-mode delamination fracture toughness of unidirectional glass/epoxy composites with mixed-mode bending apparatusComposites Science and Technology, 1996
- A numerical procedure for simulation of hydraulically‐driven fracture propagation in poroelastic mediaInternational Journal for Numerical and Analytical Methods in Geomechanics, 1990