Consumable Tool for Coating Deposition by Joint Deformation of the Base and Tool Materials
- 1 December 2019
- journal article
- research article
- Published by Pleiades Publishing Ltd in Russian Metallurgy (Metally)
- Vol. 2019 (13) , 1399-1406
Abstract
A coating made of an Al–5Mg aluminum alloy is deposited onto a substrate of the same alloy due to the joint deformation of the base and tool materials via friction. A mathematical simulation is used to choose the geometry of the tool that ensures its operability and stability during coating deposition. One-layer and multilayer coatings and butt joints of 2-mm-thick sheets are formed. The joints have a fine-grained structure with the grain size that is smaller than the grain size in the substrate by a factor of 5–10. The microhardness distribution across the deposited layers is nonuniform: the hardness increases from the substrate to the upper layer.Keywords
This publication has 7 references indexed in Scilit:
- Comparative study of severe plastic deformation at elevated temperatures of two aluminium alloys during friction surfacingJournal of Materials Processing Technology, 2017
- Friction Surfacing of Stainless Steel on Low Carbon Steel for Corrosion Resistance Application-An Experimental ApproachInternational Journal of Mechanical and Production Engineering Research and Development, 2017
- Friction surfacing of titanium alloy with aluminium metal matrix compositeSurface Engineering, 2011
- Microstructural evolution during friction surfacing of tool steel H13Materials & Design (1980-2015), 2011
- Friction surfacing: Novel technique for metal matrix composite coating on aluminium–silicon alloySurface Engineering, 2009
- Study of the interfacial phenomena during friction surfacing of mild steel with tool steel and inconelJournal of Materials Science, 1998
- The effect of metal type and multi-layering on friction surfacingJournal of Materials Processing Technology, 1996