Edge Control in the Computer-Controlled Optical Surface
Open Access
- 25 September 2021
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 12 (10) , 1154
Abstract
The computer-controlled optical surface (CCOS) can process good optical surfaces, but its edge effect greatly affects its development and application range. In this paper, based on the two fundamental causes of the CCOS’s edge effect—namely the nonlinear variation of edge pressure and the unreachable edge removal—a combined polishing method of double-rotor polishing and spin-polishing is proposed. The model of the combined polishing method is established and theoretically analyzed. Combined with the advantages of double-rotor polishing and spin-polishing, the combined polishing process can achieve full-aperture machining without pressure change. Finally, the single-crystal silicon sample with a diameter of 100 mm is polished by the combined polishing process. The results show that, compared with the traditional CCOS polishing, the residual error of the sample after the combined polishing process is more convergent, and the edge effect is effectively controlled.Keywords
Funding Information
- National Natural Science Foundation of China (51835013, 51991371)
- the Science Challenge Project of China (TZ2018006-0101-01)
- the Open Project of State Key Laboratory of Digital Manufacturing Equipment and Technology (DMETKF2020023)
This publication has 15 references indexed in Scilit:
- Characterization of the tool influence function in a dual-axis wheel polishing process to achieve high material removal ratesPrecision Engineering, 2018
- Research on edge-control methods in CNC polishingJournal of the European Optical Society-Rapid Publications, 2017
- Optimization technique for rolled edge control process based on the acentric tool influence functionsApplied Optics, 2017
- Edge control in a computer controlled optical surfacing process using a heterocercal tool influence functionOptics Express, 2016
- Modeling of edge tool influence functions for computer controlled optical surfacing processThe International Journal of Advanced Manufacturing Technology, 2015
- Edge effect modeling and experiments on active lap processingOptics Express, 2014
- Edge control in CNC polishing, paper 2: simulation and validation of tool influence functions on edgesOptics Express, 2013
- Edges in CNC polishing: from mirror-segments towards semiconductors, paper 1: edges on processing the global surfaceOptics Express, 2012
- A grinding-based manufacturing method for silicon wafers: generation mechanisms of central dimples on ground wafersInternational Journal of Machine Tools and Manufacture, 2006
- Fabrication of Aspherics Using a Mathematical Model for Material RemovalApplied Optics, 1974