Loss Mechanisms Determining the Quality Factors in Quartz Tuning Forks Vibrating at the Fundamental and First Overtone Modes
- 5 July 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 65 (10) , 1951-1957
Abstract
Quartz tuning forks (QTFs) are piezo-transducers that have been implemented for numerous applications, such as chemical gas sensing, atomic force microscopy, rheology, and industrial process control. The most important parameter for QTFs' sensing application is the resonance quality factor (Q-factor). An experimental investigation and theoretical analysis of the influence of QTFs' geometries on the Q-factor of the flexural fundamental and first overtone resonance modes are reported. The resonance frequencies and related Q-factors for five different QTFs have been measured. The QTF response was recorded at different air pressures to investigate the influence of the surrounding medium on the Q-factor. A data analysis demonstrated that air viscous damping is the dominant energy dissipation mechanism for both flexural modes. Thermoelastic and support losses are additional contributions that depend on the QTF geometry. A study of the QTF damping mechanism dependence upon the prong geometry is also provided.Keywords
Funding Information
- Thorlabs GmbH, within PolySense, a Joint-Research Laboratory
- Welch Foundation (R4925S)
This publication has 26 references indexed in Scilit:
- Dynamics of quartz tuning fork force sensors used in scanning probe microscopyNanotechnology, 2009
- Introduction to the quartz tuning forkAmerican Journal of Physics, 2007
- Attachment loss of micromechanical and nanomechanical resonators in the limits of thick and thin support structuresJournal of Applied Physics, 2007
- An analytical model for support loss in micromachined beam resonators with in-plane flexural vibrationsSensors and Actuators A: Physical, 2003
- Noncontact scanning force microscopy based on a modified tuning fork sensorReview of Scientific Instruments, 2000
- A low-temperature dynamic mode scanning force microscope operating in high magnetic fieldsReview of Scientific Instruments, 1999
- High-speed force sensor for force microscopy and profilometry utilizing a quartz tuning forkApplied Physics Letters, 1998
- Dependence of the quality factor of micromachined silicon beam resonators on pressure and geometryJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1992
- Miniaturization of Tuning ForksScience, 1968
- Internal Friction in Solids II. General Theory of Thermoelastic Internal FrictionPhysical Review B, 1938