Geometrical parameters influence on the Hall effect sensors offset and drift
- 1 July 2011
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 145-148
Abstract
Several Hall sensor configurations have been integrated in CMOS technology and analyzed in terms of offset at room temperature and offset drift. We looked for the best geometry that would minimize the offset and its drift. The targeted specification was ±30 μT for offset at room temperature and ±0.3 μT/°C for the drift. The measurement setup developed allows a clean, reliable and fast analysis of a high number of the same type of cell, located on different positions on the chip. Geometrical correction factor maximization was also performed for small sensing contacts Hall structures in order to ensure maximum sensitivity.Keywords
This publication has 8 references indexed in Scilit:
- An improved compact model of cross-shaped horizontal CMOS-integrated Hall-effect sensor2010
- Modeling Package-Induced Effects on Molded Hall SensorsIEEE Transactions on Advanced Packaging, 2008
- Dynamic low-frequency noise cancellation in quantum well Hall sensors (QWHS)Sensors and Actuators A: Physical, 2008
- Linear displacement sensor using a new CMOS double-hall deviceSensors and Actuators A: Physical, 2007
- A Hall Sensor Analog Front End for Current Measurement With Continuous Gain CalibrationIEEE Sensors Journal, 2007
- CMOS hall sensor using dynamic quadrature offset cancellation2006
- Hall Effect Devices2004
- Offset reduction in silicon Hall sensorsSensors and Actuators A: Physical, 2000