Bond strength performance of a self-curing bulk-fill restorative system and light-cured restorative systems after aging: an in vitro study
Authors:
Open Access
- 27 August 2026
- journal article
- research article
- Published by Springer Nature in Odontology
- p. 1-10
Abstract
The microtensile bond strength (µTBS) and failure patterns of a self-curing bulk-fill restorative system (STELA, SDI) were investigated and compared with those of a light-cured bulk-fill and a conventional light-cured restorative system following short- and long-term aging in artificial saliva. Forty-eight human teeth were randomly assigned to three groups ( n = 16): G1, self-curing bulk-fill restorative system; G2, light-cured bulk-fill restorative system; and G3, conventional light-cured restorative system applied incrementally. Intact restored teeth were stored in artificial saliva for either 24 h or 18 months ( n = 8 per condition) and were sectioned only after completion of the respective aging period to obtain five beam-shaped specimens (≈ 0.9 mm²). The tooth was considered the experimental unit. Specimens were stored for either 24 h or 18 months ( n = 8 per condition). µTBS was assessed at a crosshead speed of 1 mm/min, and failure modes were determined using stereomicroscopy, with representative samples analyzed by scanning electron microscopy. Data were subjected to two-way ANOVA and Tukey’s post hoc test (α = 0.05). Bond strength was significantly influenced by both restorative system and aging time ( p < 0.001). A significant interaction between restorative system and aging condition was also detected ( p < 0.001). G2 exhibited the lowest µTBS values and a higher prevalence of adhesive failures. In contrast, G1 showed bond strength comparable to G3 and significantly higher than G2. Cohesive failures predominated in G1 and G3, whereas adhesive failures were more frequent in G2. Within the limitations of this in vitro study, the self-curing bulk-fill restorative system demonstrated adhesive performance similar to the conventional restorative system and preserved its relative behavior after aging, under the respective adhesive strategies recommended by the manufacturers.Keywords
Funding Information
- Centro Universitário Do Estado Do Pará
This publication has 22 references indexed in Scilit:
- Polymerization and shrinkage kinetics and fracture toughness of bulk-fill resin-compositesDental Materials, 2022
- Academy of Dental Materials guidance on in vitro testing of dental composite bonding effectiveness to dentin/enamel using micro-tensile bond strength (μTBS) approachDental Materials, 2017
- Polymerization shrinkage kinetics and shrinkage-stress in dental resin-compositesDental Materials, 2016
- Polymerization stress evolution of a bulk-fill flowable composite under different compliancesDental Materials, 2016
- Resin composite—State of the artDental Materials, 2011
- Polymerization stress, shrinkage and elastic modulus of current low-shrinkage restorative compositesDental Materials, 2010
- Durability of resin–dentin bonds: Effects of direct/indirect exposure and storage mediaDental Materials, 2007
- Hygroscopic and hydrolytic effects in dental polymer networksDental Materials, 2006
- Elution study of unreacted Bis‐GMA, TEGDMA, UDMA, and Bis‐EMA from light‐cured dental resins and resin composites using HPLCJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2005
- Towards the elucidation of shrinkage stress development and relaxation in dental compositesDental Materials, 2004