Improving the efficiency of fully hydrocarbon-based proton-exchange membrane fuel cells by ionomer content gradients in cathode catalyst layers
Open Access
- 30 September 2022
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Materials Advances
- Vol. 3 (23) , 8460-8468
Abstract
Recently, the cell performances of fully hydrocarbon-based fuel cells approached those of cells with perfluorinated ionomers. Most studies used a low catalyst layer ionomer content (∼10 wt%) to enable the highest performance. However, such low ionomer contents can cause a lower cell performance, especially under application-relevant, i.e. reduced humidities (≤50% relative humidity). This work systematically investigates ionomer content gradients in cathode catalyst layers based on hydrocarbon ionomer. A graded ionomer content in the catalyst layer with a higher ionomer content in the vicinity of the membrane (I/C = 0.4, 25% of total layer) and a lower ionomer content (I/C = 0.2, 75% of entire layer) near the gas diffusion layer was found to ensure sufficient proton conductivity without compromising reactant transport. In single-cell tests at hot and dry operation conditions (H2/air, 95 °C and 50% RH), the graded layer enabled both significantly improved current density at relevant cell potentials vs. a monolithic catalyst layer (496 mA cm−2 vs. 367 mA cm−2@0.7 V) and slightly increased peak performance (0.76 W cm−2 vs. 0.71 W cm−2). Under the given conditions, the performance of the graded layer is similar to that of a Nafion catalyst layer. At 80% RH, the hydrocarbon-graded catalyst layer outperforms the Nafion catalyst layer at high current densities.Keywords
Funding Information
- Bundesministerium für Forschung, Technologie und Raumfahrt (03SF0579B)
- Bundesministerium für Verkehr und Digitale Infrastruktur (03B10706F)
This publication has 42 references indexed in Scilit:
- Estimation of electrode ionomer oxygen permeability and ionomer-phase oxygen transport resistance in polymer electrolyte fuel cellsPhysical Chemistry Chemical Physics, 2013
- Hydrocarbon proton conducting polymers for fuel cell catalyst layersEnergy & Environmental Science, 2011
- Ionomer content in the catalyst layer of polymer electrolyte membrane fuel cell (PEMFC): Effects on diffusion and performanceInternational Journal of Hydrogen Energy, 2011
- Influence of ionomer content on the structure and performance of PEFC membrane electrode assembliesElectrochimica Acta, 2010
- Significant improvement in cathode performance for proton exchange membrane fuel cell by a novel double catalyst layer designJournal of Power Sources, 2010
- Effect of Nafion® gradient in dual catalyst layer on proton exchange membrane fuel cell performanceInternational Journal of Hydrogen Energy, 2008
- Analysis of proton exchange membrane fuel cell polarization losses at elevated temperature 120°C and reduced relative humidityElectrochimica Acta, 2007
- Cathode Catalyst Utilization for the ORR in a PEMFCJournal of the Electrochemical Society, 2007
- Dependence of PEM fuel cell performance on catalyst loadingJournal of Power Sources, 2004
- Catalyst gradient for cathode active layer of proton exchange membrane fuel cellElectrochimica Acta, 2000