Abstract
The DIW approach offers numerous benefits, including expedited prototyping, cost-effectiveness, reduced waste in manufacturing, and enhanced design flexibility. It's currently a popular production method for building materials and has great potential for porous and electronic materials. In this study, porous cupric oxide (CuO) ceramics were fabricated using a direct ink writing (DIW) approach based on a copper particle–laden aqueous precursor. The ink formulation was optimized to achieve stable extrusion and crack-free green bodies, yielding a final composition of 68.0 wt% Cu, 31.3 wt% water, and 0.6 wt% CMC. Following oxidation and sintering in air, the printed structures exhibited a bulk density of 3.60 ± 0.20 g cm⁻³ and a corresponding theoretical porosity of 43.7 ± 0.9%. X-ray diffraction confirmed nearly phase-pure monoclinic CuO with no detectable Cu or Cu₂O residues. The printed components exhibited an interconnected, porous microstructure and a four-point-probe resistivity of 10.5 ± 0.3 Ω·m at 25 °C, reflecting the influence of high porosity on charge transport. The DIW route demonstrated here provides a controllable pathway for producing porous CuO architectures with tunable microstructure and moderate electrical conductivity. These characteristics suggest potential applicability in gas filtration, catalytic supports, and electrochemical sensing; however, device-level validation is still required to fully assess functional performance.

This publication has 55 references indexed in Scilit: