Upcycling Used Tyre Rubber into Carbon Adsorbents: Effect of Physical Activation on Porous Structure and Comparative Evaluation for p-Chlorophenol Removal
Open Access
Abstract
The porous architecture of carbons derived from polymeric waste is largely governed by the physical activation atmosphere. In this work, used tyre rubber (UTR) was converted into carbonaceous adsorbents by pyrolysis followed by physical activation in air, CO2 or steam. The influence of the activation route on porous structure, surface chemistry and adsorption performance was systematically investigated. The materials were characterised by N2 adsorption at −196 °C, mercury intrusion porosimetry, scanning electron microscopy (SEM), FT-IR spectroscopy and point-of-zero-charge (pHpzc) measurements. The resulting materials were evaluated for the removal of p-chlorophenol from aqueous solution and comparatively assessed against three commercial carbon materials. Steam activation proved to be the most effective treatment, increasing the BET surface area from 64 to 344 m2 g−1 and the micropore volume from 0.05 to 0.23 cm3 g−1 while generating a hierarchical micro-/mesoporous structure that significantly enhanced pore accessibility and mass transport. Among the UTR-derived carbons, the steam-activated sample exhibited the highest equilibrium p-Cp uptake and adsorption kinetics approaching those of a commercial activated carbon despite its lower specific surface area. Kinetic and equilibrium analyses demonstrated that adsorption performance depends not only on the extent of microporosity but also on pore accessibility and network connectivity, highlighting the critical role of transport mesoporosity in facilitating molecular diffusion towards adsorption sites. The adsorption results are consistent with an important contribution from accessible microporosity, while π–π interactions between p-chlorophenol and aromatic carbon domains may also contribute. These findings demonstrate that tailoring porous structure through physical activation provides an effective strategy for transforming UTR into high-performance carbon adsorbents and establishes robust processing–structure–property relationships that can guide the rational design of waste-derived carbon adsorbents.Keywords
Funding Information
- Ministerio de Ciencia e Innovación (CTM2008-03636)
- Junta de Extremadura and European Funds for Regional Development (GR18013)
This publication has 78 references indexed in Scilit:
- A review of enhancement of chlorophenol bioremediation using synergistic effects between zero-valent iron and microorganismsBiodegradation, 2025
- Comparative study of CO2 and steam activation on carbon-derived tire waste for effective arsenic removal from waterInternational Journal of Environmental Science and Technology, 2025
- KOH-treated tire pyrolyzed carbon as green and easily available adsorbent for Bisphenol A and Methylene blue adsorptionEnvironmental Science and Pollution Research, 2024
- Adsorption of chlorophenols on activated pine sawdust-activated carbon from solution in batch modeEnvironmental Science and Pollution Research, 2022
- Emerging Technologies Supporting the Transition to a Circular Economy in the Plastic Materials Value ChainCircular Economy and Sustainability, 2022
- Structure-oriented conversions of plastics to carbon nanomaterialsCarbon Research, 2022
- Human Exposure to Environmental Pollutants and Associations with Non-Hodgkin Lymphoma: A ReviewExposure and Health, 2021
- Crushed Rubber from Used Tires for Thermal Insulation of Walls and Flat Roofs: Modeling, Validation and Comparison with Conventional TechnologyArabian Journal for Science and Engineering, 2021
- Processing and characterization analysis of pyrolyzed oil rubber (from waste tires)‐epoxy polymer blend composite for lightweight structures and coatings applicationsPolymer Engineering & Science, 2019
- Adsorption of p-chlorophenol and p-nitrophenol in single and binary systems from solution using magnetic activated carbonKorean Journal of Chemical Engineering, 2019