SOLID PARTICLE AIRJET EROSION AND CORROSION BEHAVIOR OF AA6063 ALUMINUM ALLOY
- 2 February 2024
- journal article
- research article
- Published by World Scientific Pub Co Pte Ltd in Surface Review and Letters
- Vol. 31 (09)
Abstract
Aluminum alloy 6063 has excellent mechanical properties and it is used in automotive industries. This research focuses on solid particle airjet erosion behavior in different input parameters such as mass flow rate of 2, 3, and 4[ ]gm/min, impingement angle of 30∘, 60∘, and 90∘ and erodent velocity of 100, 150, and 200[ ]m/s. The alumina erodent is mixed with an airjet which acts as an impingement fluid jet. Taguchi was utilized for investigating the influence of the process parameter on erosion rate, and ANOVA was performed to evaluate the parameter contribution. The impingement velocity is the most significant parameter to reduce the erosion rate rather than the impingement angle and the mass flow rate. The increase in velocity of the impingement fluid jet accelerates the erosion rate due to the high kinetic energy impact. The desirability approach is used to optimize the input parameters. At 99% confidence levels, the models were considered significant. The importance of the factor is increased by a reduced p-value. From the overall analysis, the optimum conditions of solid particle airjet erosion are impingement angle of 90∘, erodent velocity of 100[ ]m/s and erodent flow rate of 2[ ]gm/min. Utilizing the cyclic sweep approach, corrosion behavior and NaCl solution are involved in the test of AA6063. As the corrosion current density increased, the corrosion potential became more positive.Keywords
This publication has 33 references indexed in Scilit:
- High-temperature solid particle erosion characteristics and damage mechanism of AlxCoCrFeNiSi high-entropy alloy coatings prepared by laser claddingIntermetallics, 2023
- Optimization of solid particle erosion behaviour of waste marble dust filled glass fiber polymer composite using Taguchi approachMaterials Today: Proceedings, 2021
- Application of Desirability Function Approach for Optimized Process Parameters of Electrical Discharge Alloying of Al 7075 with Nickel PowderTransactions of the Indian Institute of Metals, 2019
- An investigation of abrasive and erosion behaviour of AA 2618 reinforced with Si3N4, AlN and ZrB2 in situ composites by using optimization techniquesArchives of Civil and Mechanical Engineering, 2017
- Role of Process Variables on the Solid Particle Erosion of Polymer Composites: A Critical ReviewSilicon, 2013
- Applications of utility concept and desirability function for materials selectionMaterials & Design (1980-2015), 2013
- Fabrication characteristics and mechanical behaviour of rice husk ash – Alumina reinforced Al-Mg-Si alloy matrix hybrid compositesJournal of Materials Research and Technology, 2013
- Tribo-performance analysis of red mud filled glass-epoxy composites using Taguchi experimental designMaterials & Design (1980-2015), 2009
- Investigation of erosion–corrosion of 3003 aluminum alloy in ethylene glycol–water solution by impingement jet systemCorrosion Science, 2009
- Study of surface interactions of ionic liquids with aluminium alloys in corrosion and erosion–corrosion processesApplied Surface Science, 2007