Enhanced Electrochemical Sensitivity and Performance Using 3D Printed and Screen Printed Interdigitated Three-Electrode System
- 29 August 2025
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nanobioscience
- Vol. 25 (1) , 45-51
Abstract
Three-electrode miniaturized interdigitated system (IDEs) for electrochemical measurements with enhanced sensitivity and performance was reported here. The system included a reference electrode, a counter electrode, and a working electrode, all configured as interconnected electrodes. Present work focused on optimizing the number of working electrodes and their geometric parameters to achieve peak performance, with bench marking system Potassium Ferricyanide. This optimization addressed the critical interplay between capacitance, resistance, sensitivity, and aspect ratio. Unlike previous configurations where the reference electrode was separated from the interdigitated design, the present approach integrates the reference electrode into the interdigitated configuration, greatly increasing sensitivity. Despite using a low-cost conductive material such as carbon PLA (polylactic acid) for 3D printed (3DP) electrodes, in a three-electrode interdigitated system, the current observed at the oxidation peak showed a significant increase of 97-98%, while the reduction peak exhibits an increase of 65-66% compared to the two-electrode interdigitated system. The screen-printed (SP) electrodes used for design validation exhibited minimal variation in cycles in a two working electrode interdigitated configuration. This progress highlighted the potential of interconnected electrodes in developing susceptible and efficient electrochemical sensors.Keywords
This publication has 33 references indexed in Scilit:
- Microfluidic electrochemical device for real-time culturing and interference-free detection of Escherichia coliAnalytica Chimica Acta, 2022
- New carbon black-based conductive filaments for the additive manufacture of improved electrochemical sensors by fused deposition modelingMicrochimica Acta, 2022
- Variation of the Electrical Conductivity of PLA‐Based Composites with a Hybrid of Graphene and Carbon Black During 3D PrintingMacromolecular Materials and Engineering, 2022
- IoT enabled microfluidic colorimetric detection platform for continuous monitoring of nitrite and phosphate in soilComputers and Electronics in Agriculture, 2022
- Conductivity and mechanical properties of carbon black-reinforced poly(lactic acid) (PLA/CB) compositesIranian Polymer Journal, 2021
- Green activation using reducing agents of carbon-based 3D printed electrodes: Turning good electrodes to greatCarbon, 2021
- Activation of edge plane pyrolytic graphite in screen printed carbon electrodes on OHP sheet, Whatman paper and textile substratesJournal of Applied Electrochemistry, 2020
- On the impedance response of interdigitated electrodesElectrochimica Acta, 2019
- Design and Realization of a Planar Interdigital Microsensor for Biological Medium Characterization2015
- Voltammetry on fractalsSolid State Communications, 2000