Numerical simulation of blow molding—Viscoelastic flow analysis of parison formation
Authors:
- 1 October 1995
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 35 (19) , 1546-1554
Abstract
The simulation of the parison formation process in blow molding has been studied. The flow field was divided into two regions, namely, the extrudate swell region near the die lip and the parison formation region after the exit swell. In the swell region, we predicted the swelling ratio and residual stress distribution for high Weissenberg numbers for steady planar well using the 1‐mode Giesekus model. In the parison formation region, the flow is assumed to be an unsteady unaxial elongational flow including drawdown and recoverable swell and is modeled using the 10‐mode Giesekus model. We calculated the time course of parison length and thickness distribution, and compare the calculation results of parison length with experimental data. It was found that the predicted values agreed rather well with the experimental values. The calculation results could especially predict the shrink‐back, which is the phenomenon where the parison length becomes shorter after the cessation of extrusion, and it was found tat this was caused by the recoverable swell of the parison, which depends on the tensile stress generation in the die. Various flow rates and die geometries were studied and confirmed the reliability and usefulness of the method.Keywords
This publication has 14 references indexed in Scilit:
- Noncontact measurement of parison thickness profiles affected by swell and sag in continuous extrusion blow moldingPolymer Engineering & Science, 1992
- Numerical Simulation of Die Swell of Polymer Melts in Extrusion from Annular DiesSeikei-Kakou, 1990
- A new mixed finite element for calculating viscoelastic flowJournal of Non-Newtonian Fluid Mechanics, 1987
- An experimental investigation of capillary extrudate swell in relation to parison swell behavior in blow moldingPolymer Engineering & Science, 1986
- A model for parison behavior in the extrusion blow molding processAIChE Journal, 1985
- Theoretical and experimental study of non‐isothermal deformation of a blow molding parisonAdvances in Polymer Technology, 1983
- Mathematical modeling of the blow‐molding processPolymer Engineering & Science, 1982
- Swell of extrudate from an annular diePolymer Engineering & Science, 1982
- A Simple Method for Estimating Viscosity of Highly Viscous LiquidsRubber Chemistry and Technology, 1980
- Determination of rheological parameters from parison extrusion experimentsPolymer Engineering & Science, 1978