Lifetime prediction of bonded structural patch repairs for wind turbine pitch bearing strengthening
Open Access
- 9 December 2021
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 98 (6) , 739-757
Abstract
There is a growing trend in the use of adhesively bonded patches to repair structures that are subjected to fatigue loads in an attempt to reduce the propagation of an existing crack. The fatigue lifetime prediction of the adhesive used in bonded patch repair is a state-of-the-art challenge, especially when in-service conditions must also be considered. Different approaches have been identified in the literature to analyse structural failure; the methods based on fracture mechanics seem more promising for adhesives because the presence of defects is also considered in the analysis. A considerable amount of work has been undertaken to analyse the delamination of layered structures using cohesive zone modelling (CZM). However, research analysing fatigue delamination in bonded thick-walled structures (> 30 mm) is lacking. The present work proposes a methodology to predict the lifetime of an adhesively bonded patch repair applied to a thick-walled structure, specifically looking at the bearing ring structural fatigue (RSF) life extension of a pitch bearing commonly used in wind turbines.Keywords
Funding Information
- H2020 Energy (768772)
This publication has 24 references indexed in Scilit:
- Fracture mechanics approach for failure of adhesive joints in wind turbine bladesRenewable Energy, 2014
- A procedure for the simulation of fatigue crack growth in adhesively bonded joints based on the cohesive zone model and different mixed-mode propagation criteriaEngineering Fracture Mechanics, 2011
- Side Clamped Beam (SCB) hinge system for delamination tests in beam-type composite specimensComposites Science and Technology, 2011
- A Progressive Damage Model for the Prediction of Fatigue Crack Growth in Bonded JointsThe Journal of Adhesion, 2010
- Development of a standardized procedure for the characterization of interlaminar delamination propagation in advanced composites under fatigue mode I loading conditionsEngineering Fracture Mechanics, 2009
- Simulation of delamination in composites under high-cycle fatigueComposites Part A: Applied Science and Manufacturing, 2007
- An engineering solution for mesh size effects in the simulation of delamination using cohesive zone modelsEngineering Fracture Mechanics, 2007
- Numerical Simulation of Mixed-Mode Progressive Delamination in Composite MaterialsJournal of Composite Materials, 2003
- The mixed-mode delamination of fibre composite materialsComposites Science and Technology, 1993
- Characterization of Mode I and Mixed-Mode Delamination Growth in T300/5208 Graphite/Epoxy1985