Influence of the ferritic-pearlitic steel microstructure on surface roughness in broaching of automotive steels
- 16 October 2017
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 1896 (1) , 090011
Abstract
The aim of this work is to characterize the effect of microstructural parameters on surface roughness in dry broaching with a special emphasis on the ferrite-pearlite (FP) ratio. An experimental approach combining cutting and tribological tests has been developed on three grades 27MnCr5, C45, C60 covering a wide range of FP ratio. Fundamental broaching tests have been performed with a single tooth to analyse the resulting surface quality with uncoated M35 HSS tools. A specially designed open tribometer has been used to characterize the friction coefficient at the tool–chip–workpiece interface under appropriate conditions. Specific phenomena have been observed depending on the FP ratio and an interesting correlation with the tribological tests has been found. This clearly shows that friction has an important contribution in broaching and that phase distribution has to be highly considered when cutting a FP steel at a microscopic scale. This work also provides quantitative data of the friction coefficient depending on the sliding velocity and FP content which can be implemented in any analytical or numerical model of a broaching operation.Keywords
This publication has 12 references indexed in Scilit:
- Local Residual Stress Distribution at the Tooth Root Surface of a Broached Steel ComponentMaterials Science Forum, 2012
- An energy based analysis of broaching operation: Cutting forces and resultant surface integrityCIRP Annals, 2012
- High Speed Broaching of Case Hardening Steel SAE 5120Procedia CIRP, 2012
- Evaluation of machinability in turning of microalloyed and quenched-tempered steels: Tool wear, statistical analysis, chip morphologyJournal of Materials Processing Technology, 2009
- A new approach for the friction identification during machining through the use of finite element modelingInternational Journal of Machine Tools and Manufacture, 2008
- An example of selection of the cutting conditions in broaching of heat-resistant alloys based on cutting forces, surface roughness and tool wearJournal of Materials Processing Technology, 2005
- Effect of microstructure and hardness on the machinability of medium-carbon chrome-molybdenum steelJournal of Materials Processing Technology, 2004
- Prediction of friction and heat flow in machining incorporating thermophysical properties of the coating–chip interfaceWear, 2004
- The effects of heat treatment on the machinability of mild steelsJournal of Materials Processing Technology, 2003
- Softening high hardenability steels for machining and cold formingJournal of Heat Treating, 1988