Toposelective vapor deposition of hybrid and inorganic materials inside nanocavities by polymeric templating and vapor phase infiltration
Open Access
- 23 August 2022
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Nanoscale Advances
- Vol. 4 (19) , 4102-4113
Abstract
Selective deposition of hybrid and inorganic materials inside nanostructures could enable major nanotechnological advances. However, inserting ready-made composites inside nanocavities may be difficult, and therefore, stepwise approaches are needed. In this paper, a poly(ethyl acrylate) template is grown selectively inside cavities via condensation-controlled toposelective vapor deposition, and the polymer is then hybridized by alumina, titania, or zinc oxide. The hybridization is carried out by infiltrating the polymer with a vapor-phase metalorganic precursor and water vapor either via a short-pulse (atomic layer deposition, ALD) or a long-pulse (vapor phase infiltration, VPI) sequence. When the polymer-MOx hybrid material is calcined at 450 °C in air, an inorganic phase is left as the residue. Various suspected confinement effects are discussed. The infiltration of inorganic materials is reduced in deeper layers of the cavity-grown polymer and is dependent on the cavity geometry. The structure of the inorganic deposition after calcination varies from scattered particles and their aggregates to cavity-capping films or cavity-filling low-density porous deposition, and the inorganic deposition is often anisotropically cracked. A large part of the infiltration is achieved already during the short-pulse experiments with a commercial ALD reactor. Furthermore, the infiltrated polymer is more resistant to dissolution in acetone whereas the inorganic component can still be heavily affected by phosphoric acid.Keywords
Funding Information
- Finnish Centre of Excellence in Atomic Layer Deposition
- National Science Foundation (DMREF-1921873)
This publication has 75 references indexed in Scilit:
- Creases and wrinkles on the surface of a swollen gelJournal of Applied Physics, 2013
- Sequential Vapor Infiltration of Metal Oxides into Sacrificial Polyester Fibers: Shape Replication and Controlled Porosity of Microporous/Mesoporous Oxide MonolithsChemistry of Materials, 2011
- Nanoscopic Patterned Materials with Tunable Dimensions via Atomic Layer Deposition on Block CopolymersAdvanced Materials, 2010
- Conjugation of Colloidal Clusters and Chains by Capillary CondensationJournal of the American Chemical Society, 2009
- Greatly Increased Toughness of Infiltrated Spider SilkScience, 2009
- Nucleation and Growth during Al2O3 Atomic Layer Deposition on PolymersChemistry of Materials, 2005
- Atomic Layer Deposition of Al2O3 Films on Polyethylene ParticlesChemistry of Materials, 2004
- Self‐Initiated Photopolymerization and Photografting of Acrylic MonomersMacromolecular Rapid Communications, 2004
- Glass transition temperature of freely-standing films of atactic poly(methyl methacrylate)The European Physical Journal E, 2003
- Fabrication and characterization of anodic aluminum oxide templateMicroelectronic Engineering, 2003