Identification of stiffness and damping coefficients of hydrostatic bearing with angled injection
- 26 April 2013
- journal article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 227 (8) , 905-911
Abstract
This study deals with the experimental results obtained for a hydrostatic/hydrodynamic bearing used in aerospace turbopumps. This supporting element, if fitted with angled injection directed against shaft rotation, can provide a stabilizing effect to the rotor by reducing the circumferential flow. In order to characterize this effect and to improve its numerical simulation, an experimental housing has been designed to test the three directions of injection (radial, 25° and 50°). Measurements were obtained for the centered bearing operating at 2 kr/min, 4 kr/min and 6 kr/min with supply pressures of 2.5 MPa, 3.5 MPa and 4.5 MPa. The test rig uses hot water (<50 ℃) as a working fluid. For given operating conditions, a set of dynamic excitations imposed to the rotor provides complex impedances that are used for identifying dynamic coefficients. According to many pressure plugs distributed along the housing, the pattern of the pressure field in the recess and the thin fluid film near the recess is reconstructed. The bearing flow rate is also measured. Static and dynamic experimental results are compared with theoretical results obtained bycombining a pressure pattern model with a bulk-flow analysis. A good agreement between the two methods is observed. The measured cross-coupled stiffness is lower than the predicted one, indicating that the benefits of angled injection are better than what was predicted.Keywords
This publication has 10 references indexed in Scilit:
- Comparison Between Numerical and Experimental Dynamic Coefficients of a Hybrid Aerostatic BearingJournal of Engineering for Gas Turbines and Power, 2012
- Determination of the Discharge Coefficient of a Thin-Walled Orifice Used in Hydrostatic BearingsJournal of Tribology, 2005
- Combined Navier–Stokes and Bulk-Flow Analysis of Hybrid Bearings: Radial and Angled InjectionJournal of Tribology, 2004
- An experimental study on oil-film dynamic coefficientsTribology International, 2004
- Numerical Study of the Pressure Pattern in a Two-Dimensional Hybrid Journal Bearing Recess, Laminar, and Turbulent Flow ResultsJournal of Tribology, 2003
- A Method for Identification of Bearing Force Coefficients and Its Application to a Squeeze Film Damper with a Bubbly LubricantTribology Transactions, 1999
- Angled Injection—Hydrostatic Bearings Analysis and Comparison to Test ResultsJournal of Tribology, 1997
- A Test Apparatus and Facility to Identify the Rotordynamic Coefficients of High-Speed Hydrostatic BearingsJournal of Tribology, 1994
- Experimental Test Results for Four High-Speed, High-Pressure, Orifice-Compensated Hybrid BearingsJournal of Tribology, 1994
- Turbulent Hybrid Bearings With Fluid Inertia EffectsJournal of Tribology, 1990