Linear CMOS power amplifier at Ka-band with ultra-wide video bandwidth
- 1 June 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 40, 220-223
Abstract
A highly linear power amplifier (PA) with ultra-wide video bandwidth is designed at a Ka-band for 5G application. To get a high linearity with high efficiency, a deep class-AB topology with 2nd harmonic control circuits is employed, reducing the 3rd order nonlinearity. Further, an efficient low-drop out (LDO) regulator is proposed to suppress the memory effect generated by the envelope and fundamental nonlinear mixing. The PA, composed of 3 cascaded common-source (CS) stages, achieves peak PAE of 21.8% at output power of 14 dBm with 22 dB gain. The 3rd order inter-modulation distortion (IMD3) at an output power of 5 dBm is under -30 dBc for a video bandwidth of 1 GHz. The PA and LDO are fabricated in a 65 nm CMOS process and occupy 0.53 mm2.Keywords
This publication has 7 references indexed in Scilit:
- Highly Linear mm-Wave CMOS Power AmplifierIEEE Transactions on Microwave Theory and Techniques, 2016
- Phase-Delay Cold-FET Pre-Distortion Linearizer for Millimeter-Wave CMOS Power AmplifiersIEEE Transactions on Microwave Theory and Techniques, 2013
- Control of IMD Asymmetry of CMOS Power Amplifier for Broadband Operation Using Wideband SignalIEEE Transactions on Microwave Theory and Techniques, 2013
- A 60-GHz Dual-Mode Class AB Power Amplifier in 40-nm CMOSIEEE Journal of Solid-State Circuits, 2013
- Minimization of Bias-Induced Memory Effects in UHF Radio Frequency High Power Amplifiers with Broadband Signals2007
- Area-efficient linear regulator with ultra-fast load regulationIEEE Journal of Solid-State Circuits, 2005
- A Comprehensive Analysis of IMD Behavior in RF CMOS Power AmplifiersIEEE Journal of Solid-State Circuits, 2004