Effect of workpiece curvature on the tool influence function during hemispherical sub-aperture tool glass polishing
- 28 January 2021
- journal article
- research article
- Published by Optica Publishing Group in Applied Optics
- Vol. 60 (4) , 1041-1050
Abstract
The influence of workpiece curvature on the tool influence function spot during polishing of fused silica glass with cerium oxide slurry, while using a rotating hemispherical pad-foam tool for a wide variety of process conditions (tool displacement, inclination angle, and rotation rate), has been investigated. (Workpiece curvature ranged from 500 mm radius concave to 43 mm radius convex.) The TIF spot decreases in diameter and increases in the peak removal rate on more convex workpieces. In contrast, the TIF spot increases both in diameter and peak removal rate on more concave workpieces. For the range of workpiece curvatures investigated, both the spot size and the peak removal rate changed significantly, as much as 2 times. An elastic sphere–sphere contact mechanics model, which utilizes both a modified displacement (that leads to a change in the applied load) as well as a mismatch factor (that influences the pressure distribution shape), has been developed. The model was validated using both offline load-displacement measurements and finite-element analysis simulations. The model quantitatively describes the measured change in the relative contact diameter and relative pressure distribution, as well as semiquantitively describes the change in the relative volumetric removal rate on a large variety of TIF spots. The change in the volumetric removal rate for convex workpieces is a result of the balance between a decreasing spot size (reducing removal) and an increasing peak pressure (increasing removal), which usually results in relatively small changes in volumetric removal. In the case of concave workpieces, the volumetric removal rate change is also governed by a similar balance, but the spot size increase contribution dominates, resulting in a significant increase in volumetric removal rate. Understanding these trends can enable methods to add greater determinism during the fabrication of freeform optics by adjusting polishing parameters (such as dwell time) while the tool translates along a workpiece surface with different local curvatures.Keywords
Funding Information
- Lawrence Livermore National Laboratory (LLNL-JRNL-816719)
- U.S. Department of Energy (DE-AC52-07NA27344)
This publication has 13 references indexed in Scilit:
- Mechanisms influencing and prediction of tool influence function spots during hemispherical sub-aperture tool polishing on fused silicaApplied Optics, 2020
- Time-varying tool influence function model of bonnet polishing for aspheric surfacesApplied Optics, 2019
- Materials Science and Technology of Optical Fabrication2018
- Modeling and analysis of sub-aperture tool influence functions for polishing curved surfacesPrecision Engineering, 2018
- Freeform optics manufacturing2017
- Fabrication of freeform optics2015
- An Integrated Manufacturing System for the Design, Fabrication, and Measurement of Ultra-Precision Freeform OpticsIEEE Transactions on Electronics Packaging Manufacturing, 2010
- Toward Deterministic Material Removal and Surface Figure During Fused Silica Pad PolishingJournal of the American Ceramic Society, 2010
- Design and fabrication of a dual-element off-axis near-eye optical magnifierOptics Letters, 2007
- New results extending the Precessions process to smoothing ground aspheres and producing freeform parts2005