STRUCTURAL CHARACTERIZATION OF WELDED AL6060-T5 ALLOY JOINTS BY FRICTION STIR SPOT WELDING UNDER CORROSION ATACK
Authors:
- Ana Cláudia Costa de OliveiraAOAna Cláudia Costa de Oliveira
- Hortencia Noronha dos SantosHSHortencia Noronha dos Santos
- Paulo Paiva Oliveira Leite DyerPDPaulo Paiva Oliveira Leite Dyer
- Silvelene Alessandra SilvaSSSilvelene Alessandra Silva
- Kahl Dick ZilnykKZKahl Dick Zilnyk
- Maria Margareth Da SilvaMSMaria Margareth Da Silva
- Getúlio de VasconcelosGVGetúlio de Vasconcelos
- Tonilson De Souza RosendoTRTonilson De Souza Rosendo
Open Access
- 25 April 2025
- journal article
- Published by UNIVAP Universidade de Vale do Paraiba in Revista Univap
- Vol. 31 (71)
Abstract
Al6060-T5 alloys are widely used in the aerospace, shipbuilding and automotive industries. Nevertheless, the conventional welding process could be weakening its resistance to corrosion. Thus, Friction Stir Spot Welding (FSSW) becomes an alternative to reduce the thermally affected zone (HAZ) at the joints. Although, persist a lack of studies, on current literature, about these welding properties; as welds its corrosion resistance. With this in mind, this present paper evaluated an Al6060-T5 alloy plates welds after periods of 336, 672 and 1008 hours into 3.5% NaCl electrolyte immersion. Where, for each period, the plates were evaluated in terms of open circuit potentials (OCP), micro hardness Vickers, elemental composition and its corrosion severity. The results shown a percentage increasing of oxygen rate (3 to 4%); identifying corrosive activity in the mixing zone. Likewise, electrochemical tests shown a greater susceptibility to corrosion at weld nearing centre regions; due to Mg and Si precipitates presence. Even so, all immersion times samples presented a mild corrosive severityKeywords
This publication has 22 references indexed in Scilit:
- Friction Stir Spot Welding-Process and Weld Properties: A ReviewJournal of The Institution of Engineers (India): Series D, 2021
- Shear strength optimization for FSSW AA6060-T5 joints by Taguchi and full factorial designJournal of Materials Research and Technology, 2020
- Investigation on interface morphology and joint configuration of dissimilar sheet thickness FSSW of marine grade Al alloyJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2019
- Effect of the energy input on the microstructure and mechanical behavior of AA2024-T351 joint produced by friction stir weldingJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2018
- Corrosion and pitting of 6060 series aluminium after 2 years exposure in seawater splash, tidal and immersion zonesCorrosion Science, 2018
- Cost of corrosion2017
- Relationship between microstructure, microhardness and corrosion sensitivity of an AA 2024-T3 friction stir welded jointCorrosion Science, 2011
- Electrochemical corrosion parameters of as-cast Al–Fe alloys in a NaCl solutionCorrosion Science, 2010
- The influence of MgSi particle reactivity and dissolution processes on corrosion in Al–Mg–Si alloysElectrochimica Acta, 2008
- Corrosion and stress corrosion cracking in supercritical waterJournal of Nuclear Materials, 2007