Directed Energy Deposition of Zirconia-Toughened Alumina Ceramic: Novel Microstructure Formation and Mechanical Performance
- 17 December 2019
- journal article
- research article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 142 (2) , 1-20
Abstract
Over the past two decades, a considerable amount of work has been done on zirconia toughened alumina (ZTA) to take advantage of the recognized toughening effect induced by ZrO2. In fabricating customized or complex-shaped ZTA parts, conventional manufacturing processes, including slip casting and powder metallurgy, are regarded as time-consuming and cost-intensive. In response to these problems, directed energy deposition (DED) has been proposed and utilized to fabricate customized ZTA parts with highly flexible features in a shorter cycle time at a lower cost. Investigations have been reported on studying effects of input variables (such as laser power) in DED of ZTA parts, however, there are very limited investigations on effects of ZrO2 content. In this investigation, the effects of ZrO2 content on microstructures and mechanical properties of DED fabricated ZTA parts are studied. Experimental results show that at lower levels of ZrO2 contents (5 wt.%, 10 wt.%, and 20 wt.%), a novel three-dimensional quasi-continuous network (3DQCN) microstructure is tailored, whereas at higher levels of ZrO2 contents (30 wt.%, 35 wt.%, and 41.5 wt.%), eutectic microstructure dominates the whole part. Both the 3DQCN microstructure and the eutectic microstructure are beneficial for toughening ZTA parts. In addition, the 3DQCN microstructure contributes to hardening ZTA parts.Keywords
This publication has 39 references indexed in Scilit:
- A review on laser deposition-additive manufacturing of ceramics and ceramic reinforced metal matrix compositesCeramics International, 2018
- Additive manufacturing of alumina using laser engineered net shaping: Effects of deposition variablesCeramics International, 2017
- Predictive modeling of surface roughness in high speed machining of AISI 4340 steel using yttria stabilized zirconia toughened alumina turning insertInternational Journal of Refractory Metals and Hard Materials, 2013
- Evaluation of mechanical reliability of zirconia-toughened alumina composites for dental implantsCeramics International, 2012
- Hydrolysis-induced aqueous gelcasting for near-net shape forming of ZTA ceramic compositesJournal of the European Ceramic Society, 2009
- Zirconia toughened alumina ceramic foams for potential bone graft applications: fabrication, bioactivation, and cellular responsesJournal of Materials Science: Materials in Medicine, 2008
- Toughening of hard nanostructural thin films: a critical reviewSurface and Coatings Technology, 2005
- Phase transitions in zirconium dioxide and related materials for high performance engineering ceramicsJournal of Materials Science, 2002
- Crack growth resistance of alumina, zirconia and zirconia toughened alumina ceramics for joint prosthesesBiomaterials, 2002
- Zirconia-toughened alumina (ZTA) ceramicsJournal of Materials Science, 1989