Momentum and heat transfer characteristics of a thin circular disk in Bingham plastic fluids
- 2 December 2017
- journal article
- research article
- Published by Taylor & Francis in Numerical Heat Transfer, Part A: Applications
- Vol. 72 (11) , 844-868
Abstract
The laminar forced convection momentum and heat transfer aspects of a circular disk oriented normal to the flow and maintained at a constant flux or a constant temperature condition in a stream of a Bingham plastic fluid are studied over wide ranges of parameters as follows: Reynolds number, Re ≤ 150; Prandtl number, 1 ≤Pr ≤ 100; Bingham number, Bn ≤ 100, and thickness-to-diameter ratio, 0.01 ≤ (t/d) ≤ 0.075. The new results on hydrodynamics are analyzed in terms of streamline plots, recirculation length, morphology of yielded/unyielded regions, and drag coefficient, and on heat transfer aspects in terms of isotherm contours, local and average Nusselt number. The flow domain is spanned by the simultaneous existence of the yielded and unyielded sub-regions, depending upon the relative strengths of the fluid inertia (Re) and yield stress (Bn). All else being equal, the rate of heat transfer is higher for an isothermal disk than that for the isoflux condition. Both the drag and average Nusselt number bear a positive dependence on the Bingham number. The drag is influenced only slightly (∼5%) by thickness (t/d); however, the heat transfer can increase on this count by up to 15% under appropriate conditions. Finally, the present numerical results on drag and Nusselt number (in terms of jH-factor) have been correlated via simple empirical equations using the modified definitions of the Reynolds (Re*) and Prandtl number (Pr*), thereby enabling a priori estimation of drag and heat transfer in a new application.Keywords
Funding Information
- Department of Science and Technology, Ministry of Science and Technology, Government of India (SB/S2/JCB-06/2014)
This publication has 70 references indexed in Scilit:
- Unsteady heat transfer from an oblate/prolate spheroidInternational Journal of Heat and Mass Transfer, 2010
- Heat transfer of a non-Newtonian fluid (Carbopol aqueous solution) in transitional pipe flowInternational Journal of Heat and Mass Transfer, 2008
- A fictitious domain method for dynamic simulation of particle sedimentation in Bingham fluidsJournal of Non-Newtonian Fluid Mechanics, 2007
- Drag on non-spherical particles: an evaluation of available methodsPowder Technology, 1999
- The yield stress—a review or ‘παντα ρει’—everything flows?Journal of Non-Newtonian Fluid Mechanics, 1999
- Creeping motion of a sphere in tubes filled with a Bingham plastic materialJournal of Non-Newtonian Fluid Mechanics, 1997
- An experimental investigation into forced, natural and combined forced and natural convective heat transfer from stationary isothermal circular disksInternational Journal of Heat and Mass Transfer, 1995
- Wall effects on free-settling velocity of non-spherical particles in viscous media in cylindrical tubesPowder Technology, 1995
- Convective Heat Transfer Measurement Involving Flow Past Stationary Circular DisksJournal of Heat Transfer, 1989
- Numerical study of the Bingham squeeze film problemJournal of Non-Newtonian Fluid Mechanics, 1984