PZT transduction of high-overtone contour- mode resonators
Authors:
- Hengky ChandrahalimHCHengky Chandrahalim
- Sunil A BhaveSBSunil A Bhave
- 27 September 2010
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
- Vol. 57 (9) , 2035-2041
Abstract
This paper presents the Butterworth-van Dyke model and quantitative comparison that explore the design space of lead zirconate titanate-only (PZT) and PZT on 3-, 5-, and 10-μm single-crystal silicon (SCS) high-overtone widthextensional mode (WEM) resonators with identical lateral dimensions for incorporation into radio frequency microelectromechanical systems (RF MEMS) filters and oscillators. A novel fabrication technique was developed to fabricate the resonators with and without a silicon carrier layer using the same mask set on the same wafer. The air-bridge metal routings were implemented to carry electrical signals while avoiding large capacitances from the bond-pads. We theoretically derived and experimentally measured the correlation of motional impedance (R X ), quality factor (Q), and resonance frequency (f) with the resonators' silicon layer thickness (t Si ) up to frequencies of operation above 1 GHz.Keywords
This publication has 5 references indexed in Scilit:
- Performance comparison of Pb(Zr0.52Ti0.48)O3-only and Pb(Zr0.52Ti0.48)O3-on-silicon resonatorsApplied Physics Letters, 2008
- Piezoelectric-on-Silicon Lateral Bulk Acoustic Wave Micromechanical ResonatorsJournal of Microelectromechanical Systems, 2008
- High-order composite bulk acoustic resonators2007
- Piezoelectric Aluminum Nitride Vibrating Contour-Mode MEMS ResonatorsJournal of Microelectromechanical Systems, 2006
- PZT material properties at UHF and microwave frequencies derived from FBAR measurements2005