First-Order Piezoresistive Coefficients of Lateral NMOS FETs on 4H Silicon Carbide
- 18 March 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 19 (15) , 6037-6045
Abstract
Stress dependent properties and modeling of lateral enhancement-mode NMOS FETS on 4H silicon carbide (4H-SiC) are described in detail for a wide range of bias conditions. NFET stress response is shown to include a strong threshold voltage component in addition to the expected mobility component, and a theoretical model for the stress dependencies closely matches the measured data. Values of the longitudinal and transverse piezoresistive coefficients are extracted from linear region measurements of the MOS transistors as a function of gate drive for the both crystallographic and chip coordinate systems. At low gate drive, threshold variations become much more important than the classic mobility terms, whereas high gate drive is utilized to extract the mobility terms from the data. Design of a four-transistor temperature compensated stress sensor rosette that requires a value of only one combined piezoresistive coefficient is also presented.Keywords
This publication has 26 references indexed in Scilit:
- Four-Wire Bridge Measurements of Silicon van der Pauw Stress SensorsJournal of Electronic Packaging, 2014
- First-Principles Simulation on Piezoresistivity in Alpha and Beta Silicon Carbide NanosheetsJapanese Journal of Applied Physics, 2011
- Inversion layer carrier concentration and mobility in 4H–SiC metal-oxide-semiconductor field-effect transistorsJournal of Applied Physics, 2010
- Multiplexed CMOS Sensor Arrays for Die Stress MappingESSCIRC 2007 - 33rd European Solid-State Circuits Conference, 2006
- The continuous spinning current (CSC) stress sensor method for the extraction of two stress components in an offset compensated mannerSensors and Actuators A: Physical, 2006
- A 90 nm logic technology featuring 50 nm strained silicon channel transistors, 7 layers of Cu interconnects, low k ILD, and 1 μm/sup 2/ SRAM cell2003
- The elastic constants of silicon carbide: A Brillouin-scattering study of 4H and 6H SiC single crystalsJournal of Applied Physics, 1997
- Errors associated with the design, calibration and application of piezoresistive stress sensors in (100) siliconIEEE Transactions on Components, Packaging, and Manufacturing Technology: Part B, 1994
- Evaluation of piezoresistive coefficient variation in silicon stress sensors using a four-point bending test fixtureIEEE Transactions on Components, Hybrids, and Manufacturing Technology, 1992
- Piezoresistive Stress Sensors for Structural Analysis of Electronic PackagesJournal of Electronic Packaging, 1991