Low Friction of Graphene Oxide Aggregates in Lubricant Oil between a Steel Ball and Glass Disk under Boundary Lubrication
Open Access
- 4 November 2022
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 7 (45) , 40983-40989
Abstract
Previously, isolated nanocarbons in lubricating oils were considered essential for good lubrication. However, we observed that graphene oxide (GO) aggregates in lubricating oil have lower frictional properties than isolated dispersed GO. The GO was dispersed in polyα-olefin (PAO) using alkylamine at different ratios of GO and alkylamine, or it was heated at different temperatures to synthesize high- and low-dispersible GO-dispersed PAO. X-ray photoelectron spectroscopy (XPS), Fourier transform infrared spectroscopy (FTIR), and Raman spectroscopy measurements showed that low-dispersible modified GOs retained many of the original GO chemical and structural features. Macrotribological tests between a steel ball and glass disk in GO-dispersed oil were conducted with a load of 5 N under boundary lubrication. The friction interface was observed in situ using an optical microscope. In the low-dispersible GO-dispersed PAO, many GO aggregates were observed through optical microscopy. Surprisingly, the friction coefficients decreased when the GO aggregates entered the friction interface and covered the contact area. The low-dispersible GO-dispersed PAO using alkylamine had the lowest friction coefficient of 0.05, as the GO aggregates covered the contact area. From microtribological tests with a load of 0.8 mN as well, it is assumed that the low friction of the GO aggregates originates due to the sliding between the weakest shear layers in the aligned multiple GO layers.Keywords
Funding Information
- Japan Society for the Promotion of Science (17H03165, 20H02057)
This publication has 26 references indexed in Scilit:
- Self-dispersed crumpled graphene balls in oil for friction and wear reductionProceedings of the National Academy of Sciences, 2016
- Tribological properties of graphene oxide as a lubricating additive in water and lubricating oilsMechanical Engineering Journal, 2015
- Preparation and Characterization of Graphene Membrane Electrode AssemblyJurnal Teknologi (Sciences & Engineering), 2014
- Chemically Functionalized Reduced Graphene Oxide as a Novel Material for Reduction of Friction and WearThe Journal of Physical Chemistry C, 2014
- Tribological properties of monolayer graphene oxide sheets as water-based lubricant additivesCarbon, 2014
- In Situ Film-Forming and Friction-Reduction Mechanisms for Carbon-Nanotube Dispersions in LubricationTribology Letters, 2012
- Tribological properties of oleic acid-modified graphene as lubricant oil additivesJournal of Physics D: Applied Physics, 2011
- The chemistry of graphene oxideChemical Society Reviews, 2009
- Chemical analysis of graphene oxide films after heat and chemical treatments by X-ray photoelectron and Micro-Raman spectroscopyCarbon, 2009
- Graphene Oxide Dispersions in Organic SolventsLangmuir, 2008