Fluid Impregnation of Deformed Preforms
Authors:
- J. SladeJSJ. Slade
- E. M. SozerESE. M. Sozer
- 1 May 2000
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 19 (7) , 552-568
Abstract
The Resin Transfer Molding (RTM) manufacturing process is frequently used to fabricate parts consisting of doubly curved shells. Woven and stitched bi-directional fabrics deform when draped over tooling surfaces with double curvatures. This deformation results in a corresponding change in the preform's permeability tensor, which will change the fluid impregnation pattern during mold filling stage. This paper presents the results of a study in which flow through deformed preforms was investigated. Experiments were conducted in which two different preforms were radially injected after being sheared to a specified angle. The resulting elliptical flowfronts were used to determine the change in the orientation and degree of anisotropy of the permeability tensor caused by the preform's deformation. The experimental results were then compared with a numerical model developed to describe flow through typical RTM preforms using a deformable unit cell. The anisotropy ratio of the principal permeability tensor was found to increase with the shearing angle as observed experimentally and was verified by the numerical model. The success of the RTM mold design and the accuracy of mold filling simulations are dependent on the use of the correct spatial permeability tensor inside the mold. A predictive model that can provide the permeability changes as a function of local shearing deformation within the draped and compacted preforms should move us closer to a realistic simulation of mold filling in net-shaped composite structures.Keywords
This publication has 14 references indexed in Scilit:
- The development of an integrated process model for liquid composite mouldingComposites Part A: Applied Science and Manufacturing, 1998
- Model resin permeation of fiber reinforcements after shear deformationPolymer Composites, 1997
- Investigation of draping and its effects on the mold filling process during manufacturing of a compound curved composite partComposites Part A: Applied Science and Manufacturing, 1997
- The effect of shear deformation on the processing and mechanical properties of aligned reinforcementsComposites Science and Technology, 1997
- Permeability model for a woven fabricPolymer Composites, 1996
- In‐plane permeability determination for simulation of liquid composite molding of complex shapesPolymer Composites, 1996
- Processing and mechanical properties of bi-directional preforms for liquid composite mouldingComposites Manufacturing, 1995
- Forming of Woven Fabric CompositesJournal of Composite Materials, 1994
- Modelling the processing and performance of preforms for liquid moulding processesComposites Manufacturing, 1994
- Algorithms for draping fabrics on doubly‐curved surfacesInternational Journal for Numerical Methods in Engineering, 1991