Atomic Layer Deposition of Al–W–Fluoride on LiCoO2 Cathodes: Comparison of Particle- and Electrode-Level Coatings
Open Access
- 19 July 2017
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Omega
- Vol. 2 (7) , 3724-3729
Abstract
Atomic layer deposition (ALD) of the well-known Al2O3 on a LiCoO2 system is compared with that of a newly developed AlWxFy material. ALD coatings (∼1 nm thick) of both materials are shown to be effective in improving cycle life through mitigation of surface-induced capacity losses. However, the behaviors of Al2O3 and AlWxFy are shown to be significantly different when coated directly on cathode particles versus deposition on a composite electrode composed of active materials, carbons, and binders. Electrochemical impedance spectroscopy, galvanostatic intermittent titration techniques, and four-point measurements suggest that electron transport is more limited in LiCoO2 particles coated with Al2O3 compared with that in particles coated with AlWxFy. The results show that proper design/choice of coating materials (e.g., AlWxFy) can improve capacity retention without sacrificing electron transport and suggest new avenues for engineering electrode–electrolyte interfaces to enable high-voltage operation of lithium-ion batteries.Keywords
Funding Information
- Basic Energy Sciences
- Vehicle Technologies Program
This publication has 21 references indexed in Scilit:
- Cobalt-Free Nickel Rich Layered Oxide Cathodes for Lithium-Ion BatteriesACS Applied Materials & Interfaces, 2013
- Towards systems materials engineeringNature Materials, 2012
- Roles of Surface Chemistry on Safety and Electrochemistry in Lithium Ion BatteriesAccounts of Chemical Research, 2012
- Ultrathin Direct Atomic Layer Deposition on Composite Electrodes for Highly Durable and Safe Li‐Ion BatteriesAdvanced Materials, 2010
- Enhanced Stability of LiCoO[sub 2] Cathodes in Lithium-Ion Batteries Using Surface Modification by Atomic Layer DepositionJournal of the Electrochemical Society, 2010
- First-cycle irreversibility of layered Li–Ni–Co–Mn oxide cathode in Li-ion batteriesElectrochimica Acta, 2008
- XAFS Study of Tungsten L1- and L3-Edges: Structural Analysis of WO3 Species Loaded on TiO2 as a Catalyst for Photo-oxidation of NH3The Journal of Physical Chemistry C, 2008
- Microstructure of LiCoO2 with and without “AlPO4” Nanoparticle Coating: Combined STEM and XPS StudiesChemistry of Materials, 2007
- AlF[sub 3]-Coating to Improve High Voltage Cycling Performance of Li[Ni[sub 1∕3]Co[sub 1∕3]Mn[sub 1∕3]]O[sub 2] Cathode Materials for Lithium Secondary BatteriesJournal of the Electrochemical Society, 2007
- TEM Study of Electrochemical Cycling‐Induced Damage and Disorder in LiCoO2 Cathodes for Rechargeable Lithium BatteriesJournal of the Electrochemical Society, 1999