Unsteady in-cylinder heat transfer in a spark ignition engine: Experiments and modelling
Authors:
- 1 June 2001
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering
- Vol. 215 (6) , 747-760
Abstract
Instantaneous heat flux measurements have shown that, in the expansion stroke, heat can flow from the wall into the combustion chamber, even though the bulk gas temperature is higher than the wall temperature. This unexpected result has been explained by modelling of the unsteady flows and heat conduction within the gas side thermal boundary layer. This modelling has shown that these unsteady effects change the phasing of the heat flux, compared with that which would be predicted by a simple convective correlation based on the bulk gas properties. Twelve fast response thermocouples have been installed throughout the combustion chamber of a pent roof, four-valve, single-cylinder spark ignition engine. Instantaneous surface temperatures and the adjacent steady reference temperatures were measured, and the surface heat fluxes were calculated for motoring and firing at different speeds, throttle settings and ignition timings. To make comparisons with these measurements, the combustion system was modelled with computational fluid dynamics (CFD). This was found to give very poor agreement with the experimental measurements, so this led to a review of the assumptions used in boundary layer modelling. The discrepancies were attributed to assumptions in the law of the wall and Reynolds analogy, so instead the energy equation was solved within the boundary layer. The one-dimensional energy conservation equation has been linearized and normalized and solved in the gas side boundary layer for a motored case. The results have been used for a parametric study, and the individual terms of the energy equation are evaluated for their contribution to the surface heat flux. It was clearly shown that the cylinder pressure changes cause a phase shift of the heat flux forward in time.Keywords
This publication has 15 references indexed in Scilit:
- Combustion analysis and cycle-by-cycle variations in spark ignition engine combustion Part 2: A new parameter for completeness of combustion and its use in modelling cycle-by-cycle variations in combustionProceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, 1998
- A temperature wall function formulation for variable-density turbulent flows with application to engine convective heat transfer modelingInternational Journal of Heat and Mass Transfer, 1997
- Turbulent Prandtl Number—Where Are We?Journal of Heat Transfer, 1994
- Comparison of two-equation turbulence models for boundary layers with pressure gradientAIAA Journal, 1993
- An experimental investigation of surface thermometry and heat fluxExperimental Thermal and Fluid Science, 1989
- Measurements and Multidimensional Modeling of Gas-Wall Heat Transfer in a S.I. EngineSAE International Journal of Advances and Current Practices in Mobility, 1988
- Heat Transfer Characteristics of a Spark-Ignition EngineJournal of Heat Transfer, 1980
- Effects of Combustion-Chamber Surface Temperature on the Exhaust Emissions of a Single-Cylinder Spark-Ignition EngineSAE International Journal of Advances and Current Practices in Mobility, 1978
- A calculation procedure for heat, mass and momentum transfer in three-dimensional parabolic flowsInternational Journal of Heat and Mass Transfer, 1972
- STUDY ON LAMINAR HEAT TRANSFER OF INSIDE GAS WITH CYCLIC PRESSURE CHANGE ON AN INNER WALL OF A CYLINDER HEAD1970